Parts and their functions
2XLR connectors (INPUT1, INPUT2)
Connect a microphone or audio unit
here.
3
3MIC/LINE switch
Set the switch to the position
corresponding to the unit connected to
the XLR connector (INPUT1 or
INPUT2).
LINE:
Set the switch to LINE when an
46 51
audio unit has been connected to
the XLR connector.
The input level is 0 dBu.
At this point, set the wind noise
reduction function of the AG-DVC30
(or AG-DVC32) to OFF.
MIC:
Set the switch to MIC when a
microphone has been connected to
the XLR connector.
The input level can be switched
2
using the ATT switch 4.
4ATT switch
Use this to switch the audio input level.
1Level controlON: �50 dBu, OFF: �60 dBu
Turn one or both of these controls toThe switch setting takes effect when
adjust the input level of the sound.the MIC/LINE switch 3 has been set
The input levels of the CH1 (leftto the MIC position.
channel) and CH2 (right channel)
5+48V switch
sound can be adjusted separately.
When the switch is set to the ON
Normally, it is recommended that the
position, +48V power (power supply for
controls be kept at the center position.
a phantom microphone) is supplied to
Minimum
the corresponding XLR connector
(INPUT1 or INPUT2).
When connecting a unit that is not
compatible with the +48V power, set
the switch to the OFF position.
MaximumConnecting a non-compatible unit
when the switch is set to the ON
OOnce the unit is mounted on the AG-
position may cause the unit to
DVC30, the audio levels of the mic
malfunction.
input signals can no longer be adjusted
using the controls on the AG-DVC30
(or AG-DVC32).
� 6 (E) � |
ACEC
