Time Code & Users Bit
Setting the users bitTime code/users bit playback
Set the VTR to the menu mode.1Set the VTR to the STOP mode.1
(By setting the LOCAL/MENU/REMOTE switch to
the MENU position.)
2Set TC or UB using the COUNTER button.
Select the setup menu item No.531 (UB
2TC :The time code is displayed.
PRESET) setting.
UB : The users bit is displayed.
OWhen the time code can no longer be read, it
The remaining steps are the same as for
is interpolated using the CTL signal.
setting the time code.
3Press the PLAY button.
Playback is started, and the time code appears
on the display.
If ON has been selected as the setup menu
item No.005 setting, the time code value is
superimposed onto the video signals which are
output from the VIDEO OUT2 connector.
<Notes>
OWhen the drop frame time code is read, the colon
between the seconds and frames changes to a
period.
OIf the time code signal is missing, it is automatically
compensated for by the CTL signal.
What is displayed is shown below.
Superimposed display
T2R00 : 07 : 04 : 24
An asterisk (2) appears when
the time code signal is missing.
In the case of a drop frame, the colon
between the seconds and frames changes
to a period.
Counter display
TC00 : 07 : 04 : 24
UB
The display flashes when the
time code signal is missing.
In the case of a drop frame, the colon
between the seconds and frames changes
to a period.
18 |
ACEC
