Parts and their functions
Shooting (recording)/playback
function section (3)
:
9798
7SHUTTER switch:SDI switch
This is set to ON when the electronic shutter is toThis is used to select the video and audio signals
be used. When the SEL side is pressed, thewhich are to be output from the HD SDI OUT
shutter speed and mode display are changed in theconnector and the audio signals which are to be
range which was set ahead of time in the settingoutput from the AUDIO OUT connectors.
menu.EE/PB : During playback, the playback video and
If this switch setting is changed while the displayplayback audio signals are output; in all
mode is set to O2� or O3,� the new setting will appearother modes, the EE video and EE audio
at the shutter display position on the viewfindersignals are output.
screen.EE: The EE video and EE audio signals are
(Example: O: 1/120�, O: 1/61.2�)output at all times.
8ECU REMOTE (remote control) connector (6-OFF : Signal output is stopped. (This serves
pin)effectively as a power-conserving mode.)
<Note>
The AJ-EC3 extension control unit (optionalWith the settings at shipment, this function does not
accessory) is connected here.work at the OFF position when a cable is connected
<Note> to the HD SDI OUT connector. For further details,
Before connecting or disconnecting the remoterefer to the FUNCTION screen (page 95) of the
control cable, be absolutely sure to set the POWERVTR menu.
switches on the unit and extension control unit to
the OFF position.During recording, the HD SDI OUT output signals
9HD SDI OUT connector (BNC)cannot be switched from ON to OFF or vice versa.
The HD SDI signals (video and audio) for theThe status set prior to the commencement of
monitor in accord with the position of the MONITORrecording is maintained.
OUT SDI switch : are output from here.
When the SDI switch is at OEE/PB,� the EE video
and EE audio signals will be output during
recording and the playback video and playback
audio signals will be output during playback.
When the SDI switch is at OEE,� the camera video
signals are output at all times.
When the CHARACTER switch is set to ON while
performing the menu settings, it is possible to
superimpose the setting menus onto the pictures
being shot so that they can be checked on the
monitor screen.
15 |
ACEC
