Status Displays Inside the Viewfinder Screen
1Extender display
This is displayed when the lens extender is being used.
2Shutter speed/mode display
This displays the shutter speed or shutter mode setting.
OFF (1/60):Fixed at 1/60 (sec.)
1/100, 1/120, 1/250, 1/500, 1/1000:
Shutter speeds (seconds) during standard mode.
1/63.2-1/201.9 (SYNCHRO SCAN):
Synchro scan mode is selected.
3Remaining tape length display
This indicates the remaining tape length (minutes) for the VTR during recording.
Remaining tape length displayRemaining tape length display
(25 Mpbs)(50 Mbps)
Remaining tapeRemaining tape
DisplayDisplay
lengthlength
F-60Full to 60 minutesF-30Full to 30 minutes
60-5560 to 55 minutes30-2530 to 25 minutes
55-5055 to 50 minutes25-2025 to 20 minutes
50-4550 to 45 minutes20-1520 to 15 minutes
45-4045 to 40 minutes15-1015 to 10 minutes
40-3540 to 35 minutes10-510 to 5 minutes
35-3035 to 30 minutes5-05 to 0 minutes
30-2530 to 25 minutes
25-2025 to 20 minutes
20-1520 to 15 minutes
15-1015 to 10 minutes
10-510 to 5 minutes
The ?5-0? display flashes when there is
5-05 to 0 minutes
less than 3 minutes of tape remaining.
4Remaining battery level display
When an Anton Bauer Digital Magnum Series battery is used to supply power to the unit,
the remaining battery level is displayed numerically (%).
5Filter display
This displays the type of filter selected.
6White balance memory display
This displays the selected white balance automatic adjustment memory.
A: The WHITE BAL switch is set to A.
B: The WHITE BAL switch is set to B.
P: The WHITE BAL switch is set to PRST.
7Gain value display
This displays the image amplifier gain setting (dB) set by the GAIN switch.
|Note{
When using an Anton Bauer Digital Magnum Series battery, the remaining battery level display
continues to display the level for the Anton Bauer battery even if power supply is switched to an
external power source near the end of the battery?s power. However, note that the unit operates
according to the external power source.
-54- |
ACEC
