Parts and their functions(continued)
Rear panel
12 3 4 5 6 7 8 9: ;6Remote control connectors
These connectors make it possible to use two of
ANALOGREMOTEANALOG
AC INININREMOTE IN/OUTCH1PUSHAUDIOPUSHCH2PUSHTCINOUTthese VTRs or to connect this VTR to an externalCH1/2AES/EBUVIDEOSDI
ONININY
CH3/4INOFF75&1
REMOTE OUTcontroller so that the VTR can be operated from an
CH3CH4TCOUTTHRACTIVECH1/2OUTPBREF VIDEOPUSHPUSHOUGH
IN2
ONENCODER REMOTEexternal component.
CH3/4OUTOPTIONOFFCH1AUDIOCH2PR75&MON(SUPER)3
RS-232COUTLTwo remote control connectors are provided: one for
OPTION
Y1VIDEOOUT
PARALLELCH3CH4MONIN/OUT use and the other for OUT use only.
PB(WFM)2R
PR(SUPER)3IN/OUT:SIGNALGND
For connection with an external controller
SERVICE ONLY
For connection with deck-to-deck operations
OUT:
For connection with parallel run operations
1AC IN socketFor loop-through use
Connect one end of the power cord supplied to this<Note>
socket and the other end to the power outlet.
If connection is to be made to the OUT connector for
deck-to-deck operations where this VTR will serve
2DIGITAL AUDIO IN and OUT connectorsas the recorder, which of the two connectors is to be
These are the input and output connectors for digital
used can be selected using setup menu No. 212
audio signals that comply with the AES/EBU(MASTER PORT).
standards.
<Note>
7ENCODER REMOTE connector
The digital audio signals which are to be input toAn external encoder remote controller is connected
these connectors must be synchronized with theto this connector when the video output signal
video input signals. Otherwise, noise will be
settings are to be adjusted from an external
generated in the audio output signals.component.
3ANALOG COMPONENT VIDEO IN connectors
8ANALOG AUDIO IN connectors
(optional)These are the analog audio input connectors.
The analog component video signals are input to
these connectors.
9TIME CODE IN connector
This connector is used to record an external time
4ANALOG COMPOSITE VIDEO IN connectors andcode onto the tape.
75 & termination switch (optional)
The analog composite video signals are input to:TIME CODE OUT connector
these connectors. A loop-through configuration isDuring playback, the playback time code is output
featured for each pair of input connectors.
through this connector.
For termination at this VTR, set the terminationDuring recording, the time code generated by the
switch to ON.internal time code generator is output.
5REF VIDEO IN connectors and 75 & termination;SERIAL DIGITAL COMPONENT AUDIO and
switchVIDEO IN and OUT connectors
These are the input connectors of the reference
These are the input and output connectors for the
video signals.digital component audio and video signals that
Input a reference signal with color burst.comply with the ITU-R BT.656-4 standard.
For termination at this VTR, set the termination
Video signals containing superimposed information
switch to ON.can be output through the SDI OUT 3 connector.
<Note>Whether the superimposing is to be set ON or OFF
Video and audio output may be disturbed when the
is selected using the SUPER switch 4 on the front
reference video signal is not input, so it ispanel.
recommended that a system which inputs the<Note>
reference video signal be used.
The digital audio signals which are to be input to
these connectors must be synchronized with the
video input signals. Otherwise, noise will be
generated in the audio output signals.
18 |
ACEC
