Mounting methods
Mounting the lensMounting the camera
1Mount the camera on the camera mounting base, and
U-shaped groove
slide the camera toward the front along the groove until it
Lens guide
clicks into place.
NAMRG
FILTER LOCAL MONI SELY /CB
PHANTOFFABPHANTOAFFBN40N50
Lens clamp1AN20N30N40N50N60N20N30(dB)MIC1MIC(dBN602)
lever
CAMON/VTRONGAINLOWMIDOUTPUTCAMBARWB.BALA
STBYSAVEHIGHTESTPRSTSD CARD
PTTUSER SEL
Detaching the camera from the camera mounting base
Lens#ReleaseLens#LockWhile pushing the red lever, move the black lever in
the direction of the arrow, and slide the camera
toward the back.
Camera mounting base
Lens clamper
Lens lock knob
1Loosen the lens lock knob and turn the lens clamper
counterclockwise until it is horizontal.
Red leverBlack lever
2Align the guide pin at the center in the upper part of the<Note>
lens back with the U-shaped groove in the front panel,If the pin of the camera mounting base fails to return
and mount the lens onto the camera by fitting it onto theto its original position after the camera has been
lens guide.detached, push the red lever again and
simultaneously move the black lever in the direction of
3Turn the lens clamper clockwise, and tighten up the lensthe arrow to return the pin to its original position.
lock knob.Bear in mind that the camera cannot be mounted if
the pin still remains at the center.
2Lift the camera's lens clamp lever as far as it will go and
keep it at this position.
3Pull the front/back slide lock lever of the camera mount
base toward the front, and move the camera to the front.
4Insert the camera's bayonet mount by aligning its position
with the mount ring of the lens, and rotate the camera's
lens clamp lever downward to secure it.
<Note>
When the lens and camera positions cannot be aligned
properly, rotate the height adjustment knob of the camera
mount base and align the heights of the lens and
camera. When the knob is rotated clockwise, the camera
moves up; conversely, when it is rotated counterclock-
wise, it moves down.
5Push the front/back slide lock lever of the camera mount
base toward the back to secure the camera.
6Connect the camera connection optical fiber cable and
interface cable to the camera.
DownUp
Front/back slide
lock lever
Front: ReleaseBack: Lock
Height adjustment
knob
Camera mounting base
8 |
ACEC
