Menu item setting
T Electronic Shutter Mode SettingY When OSynchro Scan� has been selected as the
[Shutter Mode: Step, S/Scan, ELC]electronic shutter mode setting:
Step: Electronic shutter operates at the speed selectedBar noise can be reduced by synchro-scan adjustment
in shooting workstation scenes, for example.
by the Electronic Shutter Step/Synchro Scan
Setting.H For luminance setting at each shutter speed and synchro-
S/Scan (Synchro Scan):scan shutter speed, refer to the table below.
Electronic shutter operates at the speed selectedShutter SpeedSynchro-scanRequired luminance ratio
in Electronic Shutter Step/Synchro Scan Setting.
OFFN1
ELC: Electronic shutter is controlled to automatically1/100100.3 Hz2
adjust the luminance.1/250250.0 Hz4
Note
1/500492.2 Hz8
If Frame 1 is selected in CCD Read Out Mode Setting1/1000984.4 Hz16
(u), Electronic Shutter Mode Setting cannot be added.
1/20001.969 kHz32
1/40003.938 kHz64
U Electronic Shutter Step/Synchro Scan Setting1/100007.875 kHz160
[Step/Synchro: OFF, 1/100 to 1/10000 (Step), Notes
60.34 Hz to 15.75kHz (Synchro Scan)]Y In case of using the RCU (RCB), none of the shutter
This setting is possible only when Step or Synchro Scanspeeds N 1/250, 1/2000, 1/4000, and 1/10000 can be
is selected in Electronic Shutter Mode Setting.selected.
Y When OStep� has been selected as the electronicY In case of using the hybrid control panel, only OFF,
shutter mode setting:1/100, or ELC can be selected.
OFF: Electronic shutter is turned off.Y If the lens iris switch is at M (Manual) when operating
1/100, 1/250, 1/500, 1/1000, 1/2000, 1/4000, 1/10000:the camera alone or when the iris switch on the RCU
Electronic shutter operates at one of these(RCB) is at AUTO, ELC may not function. Set the lens
speeds as selected.iris switch to A (Auto).
Y Flickering may increase at ELC under fluorescent lights.
-44- |
ACEC
