Operation
Subcarrier phase adjustment
The subcarrier phase adjustment must be performed, when9. Select the next pan-tilt head system using the
composite signals have been set as the video input signalsCONTROL/PREVIEW MONITOR OUT SEL button, and
continue adjusting the subcarrier phase in each system
and the pictures are to be switched by a video switcher or
other equipments.concerned.
This adjustment is not necessary when component signals
have been set as the video input signals.4Y65
1. Select the pan-tilt head system using the38841
CONTROL/PREVIEW MONITOR OUT SEL button.CAMERA CONTROLPAN/TILT SET
OPERATEOPENTELEFARGAINIRISZOOM FOCUSWHITEAWCLCDLAMPDEFWIPH/FEXTNDOPTION
AUTOBALCONTRAST
MANUONA
MODEBARNGTRACING MEMORY
OFFCAMBOK
2. Connect the video switcher or other equipments to theDATA SETABCCAMERACONTROLGAIN/PEDR/BMENUOKSTPOINTARTSTART/STOPRESTORERESET
INCOMATW
VIDEO/Y OUT connector on the main unit thatTRACING/PRESET MEMORYTALLY
CALLTR/PSET M.LOCK12345678910PRIORITY
corresponds to the currently selected pan-tilt headCLOSEWIDENEAR12345AUX
LEVELCONTROL/PREVIEW MONITOR OUT SEL
IRISTRPSET
system, and connect a color monitor to the video outputTELEMEMORYAUTO11121314151617181920SPEEDUP
LOCKEMPTYFULLMANULOHIGHW
connector on the video switcher or other equipments.212223242526272829130
IRISIRIS
FOCUSFOCUS
31323334353637383940LR
3. Press the MODE button to establish the BAR mode and
CLOSENEARWIDEOPENFAR41424344454647484950CLOSENEARDOWNOPENFAR
switch the output signals from the convertible camera toZOOM/FOCUS/IRISPAN/TILT/FOCUS/IRIS
LIMITONLIMITOFF
color bar signals.
4. Press the MENU button, turn the menu setting control
(main), and set it so that the G/L SETTING item appears
at the top of the LCD panel.
GG//LL SSEETTTTIINNGG
n OOKK KKeeyy
5. Press the OK button.
The following item appears on the LCD panel.
CCAABBLLEE LLEENNGGTTHH
SSHHOORRTT
6. Turn the menu setting control (main), and set it so that
the following item appears on the LCD panel.
SSCC PPHHAASSEE
CCOOAARRSSEE::11 FFIINNEE:: ??00
7. Output both the color bar signals (signals from inside the
switcher or other equipments) serving as the reference
and the color bar signals from the camera to the color
monitor.
8. Align the phase of the color bar signals from the camera
with the phase of the color bar signals serving as the
reference.
Use the menu setting control (L) to adjust the phase in
90-degree increments and then the menu setting control
(R) to make fine adjustments.
Color bar signals from the
camera
WhiteYellowCyanGreenMagentaRedBlueBlack
Partition line
Color bar signals from the
switcher or other
equipments
27 |
ACEC
