N When images could not be transferred N
5Click the ORAM� radio button or ORAM+ROM� radio button to select the type of memoryIf an error resulted or images could not be transferred because a cable was connected or
in which the data will be saved. (Fig.13) If ORAM� is selected, the image data is saveddisconnected, turn off the switcher's power and exit the application program. Then turn the
only in the frame memory and so it cannot be used after the AW-SW350 power hasswitcher's power back on again and start up the application again.
been turned off and back on again. If ORAM+ROM� is selected, the image data is saved
in the flash memory and so it can be used after the AW-SW350 power has been turned
off and back on again. However, the actual transfer takes longer than when ORAM� is
selected.
Status after power has been turned off and back on again Transfer time
RAMTransferred image data cannot be usedApprox. 10 sec.
RAM+ROMTransferred image data can be usedApprox. 60 sec.
=The transfer times given in the above table are approximations only. The actual time
taken will depend on the performance of the host computer.
Fig.13 Memory selection
6Click the OWrite USB� button to start transferring the image data. After the completion
of the transfer, monitor the AW-SW350's PGM output and check that the image data
has been transferred. (Fig.14)
AW-SW350
program output
Click the
button
Fig.14 PGM check
3031 |
ACEC
