Read Me First
For U.S.A.
Federal Communications Commission Radio Fre-FCC requires this product to be used indoors for the fre-
quency Interference Statementquency range 5.15 to 5.25 GHz to reduce the potential for
harmful interference to co-channel Mobile Satellite sys-
Note: This equipment has been tested and found to com-
ply with the limits for a Class B digital device, pursuant to tems.
Part 15 of the FCC Rules. These limits are designed to High power radars are allocated as primary users of the
5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These
provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment gener-radar stations can cause interference with and /or dam-
age this product.
ates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions,
may cause harmful interference to radio communica-Responsible Party:
Panasonic Corporation of North America
tions. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment One Panasonic Way Secaucus, NJ 07094
does cause harmful interference to radio or television Tel No:1-800-LAPTOP5 (1-800-527-8675)
reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct FCC Regulation Notice for modem
This equipment contains a FCC approved modem.
the interference by one or more of the following measures:
z Reorient or relocate the receiving antenna.
z Increase the separation between the equipment and Getting Started
receiver.
z Connect the equipment into an outlet on a circuit differ-
ent from that to which the receiver is connected.
z Consult the Panasonic Service Center or an experi-1. This equipment complies with CFR47 Part 68 rules.
enced radio/TV technician for help.On the computer is a label that contains, among other
Warninginformation, the FCC registration number and ringer
To assure continued compliance, use only shielded inter-equivalence number (REN) for this equipment. If
required, this information must be provided to the tele-
face cables when connecting to a computer or peripheral.
Also, any changes or modifications not expressly phone company.
2. An FCC compliant telephone cord and modular plug is
approved by the party responsible for compliance could
void the user?s authority to operate this equipment.provided with this equipment. This equipment is
designed to be connected to the telephone network or
This device complies with Part 15 of the FCC Rules. premises wiring using a compatible modular jack
Operation is subject to the following two conditions:which is Part 68 compliant. See Installation Instruc-
(1)This device may not cause harmful interference, andtions for details.
(2)This device must accept any interference received, 3. The REN is used to determine the quantity of devices
including interference that may cause undesired operation.which may be connected to the telephone line. Exces-
sive RENs on the telephone line may result in the
FCC RF Exposure Warning:
z This computer is provided with a PC Card slot that devices not ringing in response to an incoming call. In
most, but not all area, the sum of RENs should not
could be used with wireless transmitter(s), which will
be specifically recommended, when they become exceed five (5.0). To be certain of the number of
available. Other third-party wireless transmitter(s) devices that may be connected to a line, as deter-
mined by the total RENs, contact the local telephone
have not been RF exposure evaluated for use with this
computer and may not comply with FCC RF exposure company.
requirements.4. If your telephone equipment cause harm to the tele-
phone network, the telephone company will notify you
<Only for models with wireless LAN>
z This equipment complies with FCC radiation exposure in advice that temporary discontinuance of service
limits set forth for an uncontrolled environment.may be required. But if advice notice isn?t practical, the
z This equipment must be installed and operated in telephone company will notify the customer as soon as
accordance with provided instructions and minimum possible. Also, you will be advised of your right to file a
1.5 cm spacing must be provided between antenna complaint with the FCC if you believe it is necessary.
and all person?s body (excluding extremities of hands, 5. The telephone company may take changes in its facili-
wrist and feet) during wireless modes of operation.ties, equipment, operations or procedures that could
z This transmitter must not be co-located or operated in affect the operation of the equipment. If this happens
conjunction with any other antenna or transmitter. the telephone company will provide advance notice in
order for you to make necessary modifications to
<Only for models with wireless LAN>maintain uninterrupted service.
This product is restricted to indoor use due to its operation 6. If trouble is experienced with this equipment, for repair
in the 5.15 to 5.25 GHz frequency range.or warranty information, please contact Panasonic
3 |
ACEC
