Starting Up/Shutting Down
3Log on to Windows.
After confirming that the hard disk drive indicator () has turned off, select the user
and input the password, then select . Until the correct password is entered, the
computer will not operate.
4Select your application.
You are able to start working on your computer.
NOTE
The power saving function is factory set, so if there is no input from a key, the touch
pad, the touchscreen (only for models with touchscreen) or an external mouse (when
one is connected) for a certain interval of time, the power to the LCD and hard disk
may be turned off. The LCD will resume operation when the touch pad, the touch-
screen (only for models with touchscreen) or an external mouse (when one is con-
nected) is used or a key is pressed.
The power to the LCD may be turned off even when an application software is being
installed. In this case, because it is conceivable that a selection dialog box will be
shown, do not press Space or Enter to attempt to resume from this condition
as doing so may trigger a selection, but instead, press a key unrelated to the direct
triggering of a selection, like Ctrl .
In addition, when the computer is left alone, it automatically enters the standby or
hibernation mode ( ?Standby/Hibernation Functions?). The computer will
resume by pressing the power switch.
Enter Password [ ]If the screen on the left is displayed immediately after you turn
on the power...
A password has been set to ensure the computer?s security.
Enter your password*1 and press Enter . ( ?Security Measures?)
When the correct password is input, the computer will start.
OperationWhen three incorrect password attempts or nothing is input for one minute, the com-
puter will power off.
1
*Supervisor Password or User Password set in the Setup Utility (not the Windows password).
16 |
ACEC
