Troubleshooting
When a problem occurs, refer to this page. If a problem appears to be related to a software
application, read the software related manual. If you still cannot troubleshoot the problem,
contact Panasonic Technical Support.
No display afterHas the computer or wireless display been set to the
powering onpower-saving mode?
To resume operation of your computer from the
condition the power of the display is off (for energy
conservation purposes), touch the screen.
An afterimage appearsIf an image is displayed for a prolonged period of time,
an afterimage may appear. Set the screensaver.
?Connection timeout? isConfirm the IP address, subnet mask, network type,
displayedand SSID settings on both the computer and theE
wireless display.
Confirm the operation of the wireless LAN on the
computer.
The wireless LAN on the computer side is compatible
with 802.11b and 802.11g, but if there is a possibility
of interference from other devices on the network, set
the computer?s wireless LAN to 802.11b only.
If your computer and the wireless display do not power
off normally due to a reason such as a network error, it
may take two or three minutes to reconnect.
Wait for a moment, then connect again.
?No server found? isPut the wireless display close to the computer.
displayedConfirm that is on the taskbar.
Confirm the IP address of the computer that has been
set on the wireless display.
?Authentication failed? isConfirm the password for both the computer and the
displayedwireless display.
?Too many clients? isDisconnect the wireless display during operation and
displayedreestablish the connection.
(To next page)
39 |
ACEC
