Display (continued)
When you want to displayChange the size of the icons, etc. using ?Icon Enlarger? ( ?Icon Enlarger?).
the fonts or icons at a largerYou can also change the settings as follows (for more details, refer to the Windows Help).
size1Select [start] - [Control Panel] - [Appearance and Themes] - [Display] - [Appearance].
2Select the font size in [Font size], and select [Effects] and then add the check mark for
[Use large icons] to increase the icon size.
3Select [OK], then select [OK].
When a video such as anThe display destination cannot be switched while a video such as an MPEG file and a
MPEG file and a DVD videoDVD video is playing. Stop playing the video before switching the display destination.
is being played with
?
WinDVD or Windows Me-
dia Player, the display desti-
nation cannot be switched
using Fn + F3
During simultaneous dis-Try changing the display by pressing Fn + F3 .
play, the screen of the exter-If you continue to experience problems, try changing the display destination in the follow-
nal display becomes disor-ing menu:
dered[start] - [Control Panel] - [Other Control Panel Options] - [Intel(R) Extreme Graphics 2M] -
[Devices]
When [Command Prompt] is set to ?Full Screen? by pressing Alt + Enter , the screen
is displayed on one of the displays only. When the window display is restored by pressing
Alt + Enter , the screen is displayed on both displays.
Simultaneous display cannot be used until Windows startup is complete (during Setup
Utility, Windows logon screen, etc.). When Fn + F3 is pressed, the screen is
displayed on the external display or the internal LCD.
Shutting Down
Windows cannot be shutIf a USB device is connected, try removing it.
down or restarted
Standby / Hibernation Function
Unable to enter standby orIf a USB device is connected to the computer (note: only for some USB devices), remove
hibernation modethe USB device temporarily. If the problem persists, restart the computer.
It may take one or two minutes to enter standby or hibernation mode.
The computer may not enter standby mode properly and seems to be frozen in the case
that the computer is communicating via the modem. If this happens, slide the power
switch for four seconds or more to forcibly turn your computer off.
If there is a disc in the DVD-ROM & CD-R/RW drive that has been formatted using B?s
CLiP, the computer will not enter standby or hibernation mode. Remove the disc.
Unable to automaticallyIf a peripheral is connected to the computer, disconnect the device.
enter standby or hiberna-When the internal LCD is closed, the computer may not enter standby or hibernation
tion modemode. In order to activate standby or hibernation automatically while using the com-
puter with the internal LCD closed, set the [Touch Pad] to [Disable] in the [Main] menu
of the Setup Utility.
If there is a disc in the DVD-ROM & CD-R/RW drive that has been formatted using B?s
Troubleshooting
CLiP, the computer will not enter standby or hibernation mode. Remove the disc.
The computer does notDid you disconnect the AC adaptor or the battery pack while the computer was in
resumestandby mode? If the computer's power supply is disconnected while the computer is in
standby mode, all unsaved data will be lost.
Did you slide the power switch and hold it for four seconds or more? If you slide the
power switch and hold it for four seconds or more, the power will be turned off forcibly. In
this case, all unsaved data will be lost.
31 |
ACEC
