GeneralSound Control
1 UpNote: The volume level can be set independently for The equalizer curve is selectable from among 4 types
2 Downeach source. (For radio, one volume setting for AM, one (FLAT, ROCK, POP and VOCAL) depending on your
volume setting for all FMs)listening category.
Setting Range: 0 to 40
Default: 18 SQ changeover
Volume (VOLUME)
The SQ category is changed every time [SQ] (Sound
Adjustment
Quality) is pressed. English
(FLAT) at frequency response:
does not emphasize any part.
Volume off (down)(Default)
Press [MUTE].
(ROCK) speedy and heavy sound:
exaggerates bass and treble.
(Down)Cancel
Caution
Y Set the volume level to low enough before the (POP) wide-ranged and deep sound:
Press [MUTE] again.
MUTE (ATT: Attenuation)AUX connection is completed. slightly emphasizes bass and treble.
Note: You can select mute or attenuation. (? page 23) Failure to observe this, the loud noise may come
Temporary Volume Off
out and damage your speakers and your hearing.
(VOCAL) clear sound:
SQ (Sound Quality) emphasizes middle tone and slightly
emphasizes treble.
The source changes as follows every time [SOURCE] Press [DISP] to return to the regular mode.
is pressed.
General, Sound Control
SQ Selection Based on Genre Notes:
AUX1 (AUX1 in) (3.5 mm � stereo) Setting of SQ, bass/treble and volume are in uenced
From line output of external sound/audio device (ex. one another. If such an in uence mentioned above
Silicon-audio player, HDD player, etc.)causes distortion to the audio signal, readjust bass/
treble or volume. (? page 22)
RadioSystem-up Connector Please refer to page 22 for the adjustment to each
speaker and an optional subwoofer.
FM1, FM2, FM3, AM (? page 14)When an optional device is connected: Bass adjustment
Shift to connected device Treble adjustment
When connecting CD changer Balance adjustment
Fader adjustment
Subwoofer level adjustment
When connecting iPod
Player
When loading CD (? page 16)
When connecting XM Receiver
(SOURCE)
When connecting Sirius Receiver
Source SelectionWhen loading MP3/WMA disc (? page 18)
OR
When an expansion module is connected:
AUX1
The devices connected to the ports 1 to 4 are
Device connected to the AUX1 terminal of this unit activated in sequence after shifting to AUX2 (device
connected to the AUX terminal of the expansion
module).
Note: For information about connectable devices,
refer to the System Upgrade Guidebook or the
instruction manual for each device.
12CQ-C3405U/C3305UCQ-C3405U/C3305U13 |
ACEC
