EE
NInstallationN
GG
LL
II
SSupplied HardwareS
HPreparationH!We strongly recommend that you wear gloves for installation work to protect yourself from injuries.
No.ItemDiagram QOty
!When bending the mounting tab of the mounting collar with a screwdriver, be careful not to injure your hands and
23!Before installation, check the radio operation with anten-fingers.24
na and speakers.qMounting Collar1
!Disconnect the cable from the negative (�) battery termi-
Insert Mounting Collar q into the
nal (see caution below).First complete the electrical connections, and
wMounting Bolt (5 mmż)1dashboard, and bend the mounting
!Unit should be installed in a horizontal position with thethen check them for correctness.(a Page 30)
1
front end up at a convenient angle, but not more thantabs out with a screwdriver.
30!.ePower Connector1
rRemovable Face Plate Case1
tTrim Plate1
30! or less
yISO Antenna Adapter1
uRemote Control1
Caution:Do not disconnect the battery terminals of a
iLithium battery (CR2025)1
car with trip or navigational computer since all user set-
Lock Lever (CC)
tings stored in memory will be lost. Instead take extra
care with installing the unit to prevent shorts.
Power Connector e
Dashboard
(a) Using the Rear Support Strap (Option)
Installation53 mm
Installation OpeningFire Wall of Car
182 mm3 mmż
The unit can be installed inTapping Screw (Option)
any dashboard having an
opening as shown at right. The dashboard should be 4.5Mounting Tabs
mm - 6 mm thick in order to be able to support the unit.Hex. Nut (Option)
Mounting Bolt w
Installation Precautions
Rear Support Strap (Option)
This product should be installed by a professional installer,
Secure the rear of the unit.
if possible.
wMounting Bolt
After fixing Mounting Bolt w and Power
In case of difficulty, please consult your nearest authorized
Connector e, fix the rear of the unit to the car
Panasonic Service Center.qMounting Collar2
body by either method (a) or (b) shown on the
1. This system is to be used only in a 12-volt, DC battery
previous page.
system (car) with negative ground.
2. Follow the electrical connections carefully (a Page 30).
Insert Trim Plate t.
(b) Using the Rubber Cushion (Option)
Failure to do so may result in damage to the unit.
3
3. Connect the power lead (red) after all other connectionsRear Support Bracket
are made.(Provided on the car)
After installation reconnect the nega-
4. Be sure to connect the battery lead (yellow) to the posi-Rubber Cushion
(Option)tive (�) battery terminal.
tive terminal (+) of the battery or fuse block (BAT) termi-
nal.4
5. Insulate all exposed wires to prevent short circuiting.
Make sure that the lock lever (C)
6. Secure all loose wires after installing the unit.
is flush with the mounting collar
7. Please carefully read the operating and installation
wMounting Bolt(not projecting outward).
instructions of the respective equipment before connect-
ing it to this unit.
qMounting Collar
Lock Lever
2627
CQ-DFX751/DFX701/DFX601NCQ-DFX751/DFX701/DFX601N |
ACEC
