EE
NInstallation(continued)N
GG
LL
II
SS
O Installation Procedures (When not using Mounting Collar w)
HMounting the Hide-away UnitH
Use the brackets supplied with your car when mounting this unit. The bracket shape and mounting method vary with car
45manufacturers, car types and manufacturing year. Please consult your nearest dealer or installer.46
Select mounting screws according to the hole positions and hole shape of the bracket.Cautions:
!Never mount the unit in any of the following locations to avoid damage due to overheating;
t Binding-Head Screw (5 mmż x 6 mm)2 pieces1. Near the heater port.
Recycle the Binding-Head Screws that fixed the transportation brackets for two more 2. Places like the dashboard or rear deck, where it may be exposed to direct sunlight.
!Do not mount the unit near the door, where it could be exposed to rain.
positions.
u Binding-Head Screw (4 mmż x 3 mm)
When using theseQ Mount the unit on the car carpet by using Velcro Tape !6.
4 piecesmounting holes
Attach the seal side of the Velcro Tape !6
to the hide-away unit, then mount the unit
on the carpet.
y Flat-Head Screw (5 mmż x 6 mm)4 pieces
Note: Some carpet materials may not be
suitable for this mounting method. In this
case, please contact your nearest
Use the supplied Spacer i if mounting hole of your car is shaped like below.
tBinding-Head ScrewPanasonic Service Center for installation.
(5 mmżx 6 mm)
!6Velcro Tape
Not used
i Spacer
Mounting Hole
of a Bracket
(in section)
Bracket
Q Unit installation by using the Mounting Brackets !3 and the Base Brackets !4.
tBinding-Head Screw Existing Bracket (R)
(5 mmżx 6 mm)
oDouble-Faced
!2 Hex. Nut (5 mmż)
Adhesive Tape
!3 Mounting Bracket
iSpacer
!0 Binding-Head Screw
Existing Bracket (L)oDouble-Faced Adhesive Tape
(5 mmż x 8 mm)
(Bracket originally
attached to the car)
Carpet
Let the bolts of the base bracket
pass the carpet.
!1 Tapping Screw (6 mmż x 20 mm)
!4 Base Bracket!5 Double-Faced Adhesive Tape
Drill for 4.8 mm diameter holes to the chassis.
Make cuts by using cutter.
* Put the tape and the base bracket together with each hole of the tape and
bracket connected so that the screw goes in at two positions.
Note: Apply an anticorrosive to the holes and tapping screws.
Caution: You run the risk of interfering with the mounting or causing damage by drilling into the gas tank, a wiring
harness, or other component.
4647
CQ-VA7300NCQ-VA7300N |
ACEC
