REMOTE CONTROL OPERATION (FOR ALL MODELS)
Programming The RemoteComponent Codes
The Universal Remote Control can be programmed toThe Universal Remote Control is capable of operating
operate many manufacturers? components, using themany component brands after entering a code. Some
component function buttons for VCR, DVD, CABLE orcomponents may not operate because the codes are not
DBS. Follow the procedures for programming your Remoteavailable due to limited memory. The Universal Remote
Control with or without a code for the component.Control does not control all features found in each model.
DeviceOperatesDefault
Write the code numbers from tables in this space.
TVTV (Panasonic Only)Panasonic Code
This will serve as a reference if you need to program
DBS/CBLDBS\CBL (Preset)Panasonic DBS Codeyour Remote Control.
VCRVCR (Preset)Panasonic Code
HDVDDVD (Preset) Panasonic Code VCR CABLE DVD
S
I
Note: Determine the manufacturer of the component and look
L
in the table for the code (found on page 11).
G
N DBS
Procedure
E
?Confirm that the external component is plugged and
operating.
?Turn the component off.
ACTION
POWER
?Press and together, for at least 5
seconds.
?Press appropriate component button on the Remote
Control VCR, DVD, CABLE or DBS.
?Enter the 3-digit component code using the Remote
Control numeric keypad (0 ~ 9 buttons).
?Press the Remote Control POWER to test the
component. If the procedure was successful, the
component will turnon.
Note: If the component does not operate with the Remote
Control, repeat the procedure using another code.
(Some brands have multiple codes). If an incorrect code
is entered, or if the procedure takes longer than 30
seconds, the programming will fail.
Programming Without A Code
This procedure searches all codes and is called the
?sequence method.?
?Confirm that the external component is plugged in
and on.
?Turn the component off.
ACTION
POWER
?Press and together, for at least 5
seconds.
?Press appropriate component button on the
Remote Control.
?Press VOL u to move forward to the next code.
Press t VOL to move backward.
?Press the Remote Control POWER to test the
component. If the procedure was successful, the
component will turn on.
Note: Repeat the above steps until the component code is
found. It may take many attempts before the correct
code isfound.
ACTION
?After the code is found, press to store the
code.
10 l |
ACEC
