HELPFUL INFORMATIONENERGY SAVING AND OPERATION
HINTS
Auto Operation Button Auto Restart Control
Y If power is resumed after a power failure, the Setting the Temperature
operation will restart automatically after 3 - 4
ECONOMYECONOMYECONOMYECONOMYPOPOPOPOWERFULWERFULWERFULWERFULPOPOPOPOWERWERWERWER SLEEPSLEEPSLEEPSLEEPTIMERTIMERTIMERTIMERminutes.Y Approximately 10% of electricity can be saved.
Y Set the temperature higher or lower than the
Y Operation will be restarted automatically under thedesired temperature.
Y Raise the front panel and press.previous operation mode and airflow direction when
power is resumed as the operation is not stopped
Cooling operation : 2!F higher
by the remote control.Heating operation : 4!F lower
Timer Setting
Automatic Operation Air Filters
Y If the remote control fails to function or has beenY When power failure occurs, the timer setting will be
cancelled. Once power is resumed, reset the timer.Y Clean the air filters every 2 weeks.
misplaced, press the Auto Operation button to startY Dirty filters may reduces cooling or heating
the Automatic operation.efficiency.
Y The Automatic operation will be activated Thunder and Lightning
Y This air conditioner is equipped with a built-in surge
immediately once the Auto operation button is Keep All Doors and Windows Closed
pressed. However, temperature cannot be adjustedprotective device. However, in order to furtherY Otherwise, cooling or heating performance will be
protect your air conditioner from being damaged by
when in this mode.abnormally strong lightning activity, you may switchreduced and electricity cost is wasted.
Y The power indicator on the indoor unit will blink until
the operation mode is selected automatically.off the circuit breaker. Outdoor Unit
Y To cancel this operation, press once more.Y Do not block the air outlet vents. Otherwise, it will
lower the cooling or heating performance.
Remote Control Signal Receiving Sound
Y To switch off the beep (Signal Receiving Sound), Timer and Sleep Mode
press the Auto Operation button for 10 secondsY To prevent wastage of electricity, use sleep mode
continuously or longer.when sleeping or Timer when going out.
A Obeep�, Obeep� sound will be heard at the
tenth seconds. Avoid Direct Sunlight
Note: A Obeep� sound will be heard at the fifthY Keep curtains or drapes closed to avoid direct
seconds;sunlight during cooling operation.
However please press continuously until you
heard Obeep�, Obeep� sound.
Y Repeat the above steps if you want to switch on the
Signal Receiving Sound.
(This is for Servicing purposes only.)
Note: If you press this button continuously for 5 to 10
seconds, Test Run operation will be performed. A
Obeep� sound will be heard at the fifth second
indicating the Test Run starts to operate.
9 |
ACEC
