Additional controls and important information.
Ventilation
The ventilation lever must be in the CLOSE position in order to maintain the
best cooling conditions.
When fresh air is necessary in the room, set the ventilation lever to the OPEN
position.
CLOSEVENTOPEN
The damper is opened and room air is drawn out.
PartB
NOTE: Before using the ventilation feature, and prior to installing the front
PartA
grille, pull down part until level with part .
AbouttheControlsontheAirConditioner
Air Direction
The direction of air can be controlled wherever you want to cool by adjusting the horizontal
louver and the vertical louver.
YVERTICAL AIR-DIRECTION CONTROLYHORIZONTAL AIR-DIRECTION CONTROL
ControlledControlled by Remote
manuallyController
The vertical air direction is adjustedThe horizontal air direction is adjusted by
by rotating the horizontal louverrotating the vertical louver right or left manually
forward or backward manually.or by Remote Controller.
How to Secure the Drain Pipe
In humid weather, excess water may cause the BASE PAN to overflow. To drain the water, remove the
DRAIN CAP and secure the DRAIN PIPE to the rear hole of the BASE PAN. Press the drain pipe into the
hole by pushing down and away from the fins to avoid injury. (See Fig.1)
Optional (CW3H02502B)
1. Remove the rubber plug and slide the chassis out
from the cabinet. (See Fig. 2)
Drain pipe
2. Install the drain pan over the corner of the cabinet
Drain capFig. 1
where you removed the plug with 4 (or 2) screws.
(See Fig.3)
COOLFANMOFTEEP/TAIIR STIMESETCNETR/EOFFOPERARWiremoteeles ConECON/ONTIONHIGHDstrolOMY
3. Connect the drain hose to the outlet located at theFAN SMEDLOWPEE
bottom of the drain pan. You can purchase the drainRemove the
rubber plug
Fig. 2
hose or tubing locally to satisfy your particular
needs. (Drain hose is not supplied). (See Fig.3)
SCREW
CABINET
4. Select the most appropriate connection from among
the figures to the right (by considering the hole of the
DRAINDRAIN HOSE
unit) to fit drain pan to your own unit. (See Fig.3)PANInside diameter17mm (5/8")
Fig. 3
5. Slide the chassis back into the cabinet. Reinstall the
cabinet screws. Secure the cabinet to chassis by
using screws. (See Fig.4)
COFAHIMEOLLONFMOAN SPhDErFTEMP/TIMEAIRGHSTIMR SWSECANETERINGT/CELOOPWiRemrelote ECFF/OERATCessONONIONDWEED
ontrolMY
Fig. 4
7 |
ACEC
