FZ2-PP.book 100 k 2376P7627F9� 1
Others
Troubleshooting
1:The power does not turn on.8:The display or images on the
1-1: Are the battery and the AC LCD monitor/Viewfinder are not
adaptor correctly connected? focused.
Check the connection.8:Set the mode dial to the mode
1-2: Is the battery sufficiently charged? corresponding to the distance to
Use a battery that has been the subject.
sufficiently charged.
9:The image will not play back.
2:As the power is turned on, it 9-1: Is the Card inside?
turns off immediately.9-2: There is no image in the Card.
2:Is the battery charge insufficient to 9-3: The mode dial is not set to
operate the camera? Charge the playback [].
battery or replace it with charged 10: The image is not displayed on
one.the television.
3:The lens and the Viewfinder are 10-1: Is the camera correctly connected
fogged.with the TV? Check it.
3:Has condensation occurred? 10-2: Set the TV to video input mode.
Carrying the digital camera from a 11: When connecting to a PC,
cold place to a warm place could images cannot be transferred.
cause condensation on the 11-1: Check that the camera is correctly
camera. Wait until condensation connected to the PC.
disappears.11-2: Is the camera correctly recognized
4:The image cannot be recorded.by the PC?
4-1: Is the Memory Card inside?12: The clock setting is reset.
4-2: Is the mode dial correctly set? 12-1: If you do not use the camera for a
Check it.long time, the clock setting may be
4-3: There is no memory capacity left reset. When the message
on the card. Before recording, [PLEASE SET THE CLOCK]
delete some images.appears, set the clock again.
5:The image is not displayed on 12-2: When you take a picture before
the LCD monitor.setting the clock, [0:00 0. 0. 0] is
5:Is the the image displayed on the recorded.
Viewfinder? Press the [DISPLAY] 13: The camera chatters when it is
button to switch to LCD monitor shaken.
display.13: This is the sound coming from the
6:The LCD monitor/Viewfinder is lens. When you turn the power
too bright or dark.[ON], the sound is stopped. This is
6:Adjust the brightness of the LCD not a malfunction.
monitor/Viewfinder.
14: Some pixels are inactive or
7:Flash does not fire. always lit on the LCD monitor.
7:Is the flash closed? Press the 14: This is not a malfunction. These
[ OPEN] button to open the pixels do not affect the recorded
flash.images.
100 |
ACEC
