ES30VP&PC.book 68 &k&& 9�9�9á2376776279�9Ţ 1
ReferenceDVDVHS
OperationPage
Cannot operate the TV.eChange manufacturer code. Some TVs cannot be operated even if you change the code.19
ePress [TV/VIDEO] to change the input mode to ?TV?.26, 51
Cannot operate the DVD.ePress [DVD] when operating DVD.10
Cannot operate the VHS.ePress [VHS] when operating VHS.10
The remote control doesn?t eThe remote control code is wrong. Change to the correct code.19
work.eThe batteries are depleted. Replace them with new ones.11
ePoint the remote control at the remote control sensor on the main unit.11
eRemove obstacles between the remote control and main unit.-
eDon?t place the signal sensor in direct sunlight or in areas that may be subject to sunlight -
exposure.
eIf you repeatedly insert discs or turn the unit on and off about 50 times or more, the recording -
or editing of DVD-R, DVD-RW (DVD-Video format), +R may be disabled.
The unit is on but cannot be eSome operations are prohibited by the disc.-
operated.eThe unit is warm (?U59? appears on the unit?s display). Wait until ?U59? disappears.-
eOne of the unit?s safety devices may have been activated.-
Reset the unit as follows:
(1) Press [POWER ? /I] on the main unit to switch to standby.
If the unit doesn?t switch to standby, press and hold [POWER ? /I] on the main unit for
about 10 seconds. The unit is forcibly switched to standby.
Alternatively, disconnect the AC power supply cord, wait for about 1 minute, then
reconnect it.
(2) Press [POWER ? /I] to turn the unit on.
Cannot eject a disc.eThe unit is recording-
eThe unit may have a problem. While the unit is off, hold down [+ ] and [CH, W ] on DVD side of -
the main unit simultaneously for about 5 seconds. Remove the disc and consult the dealer.
Startup is sloweMake sure that ?Quick Start? is set to ?On?.43
Even if ?Quick start? is set to ?On?, startup is slow if the clock is not set, there was a power
failure or the AC plug has just been connected.
eA few dozen seconds after turning on the unit, you can play a disc or start recording to discs -
other than DVD-RAM.
eStartup takes time for a few minutes after 4:00 a.m. due to system maintenance of this unit.-
Takes time to read DVD-RAMeIt may take time to read a disc if it is being used for the first time in this unit or it has not been -
used for a long time.
PicturePage
TV reception worsens after eThis can occur because the signals are being divided between the unit and other equipment. It -
connecting the unit.can be solved by using a signal booster, available from audio-visual suppliers.
The images from the unit do not eMake sure that the TV is connected to the VIDEO OUT terminal, S-VIDEO OUT terminal or 13, 15
appear on the TV.COMPONENT VIDEO OUT terminals on the unit.
Picture is distorted.eMake sure that the TV?s input setting (e.g., VIDEO 1) is correct.-
eThe TV isn?t compatible with progressive signals. Press and hold [+ ] and [Ž DVD, DUBBING] -
on DVD of the main unit at the same time for about 5 seconds. The setting will change to
interlace.
68
VQT0N92 |
ACEC
