P2-35 e.fm Page 19 Friday, December 29, 2006 5:46 PM
3Attaching the unit to the bracket.
While holding the unit with both hands, line up the unit just below the protruding sections on the
bracket. Press the unit down about 4 to 5 mm (5/32q to 3/16q) so that the protrusions on the bracket fit into
the holes on the bottom of the unit.
e Please check the following points before use.
-The bracket is securely fastened to the unit.
-The unit is not loose and cannot be lifted upwards.
Line up the protruding
sections here.
When correctly
attached, click!
you will hear a
locking sound.
Diagram of attached bracket
Use the monitor in the open
position as shown in the
Enjoying in a carillustration to the right to
prevent abnormal audio or
damage resulting from
vibrations in the car.
The angle of the monitor can
be adjusted up to about 30°.
30°
e The angle of the monitor may shift
while driving due to vibration, etc.
e Depending on the type of headrest, you Releasing the unit from the bracket
may not be able to attach the bracket.
23 cm (9 1/16q)
or lessRelease
button
In the event of an accident
etc., the unit could become 1 Press the release buttons (left and right) in
loose and cause injury.towards the center of the bracket.
2 Lift the unit up to release it.
e Do not press the release buttons any time other
than when detaching the unit from the bracket.
19
RQT8912 |
ACEC
