1@&4 64"
�?´
2. Remove the screw (a) and the� The shaver may not immediately� Do not take the housing apart as
panel cover (b).begin to charge after being placedthis can affect the watertight con-
3. Remove the two screw covers (c)into the charging adaptor after use.struction.
(using something like a tooth-Allow the shaver to sit in the charg-� Do not shave when the �sonic� vi-
pick), and 6 screws (d).ing adaptor for a few minutes andbration is activated, as it may dam-
4. Remove the back panel (e).check again to make sure that it isage your skin.
5. Lift the battery block (f) and re-being charged.
move it from the battery terminal� Do not place any metal objects likeSpecifications
sealing (g).coins and paper clips on the charg-Power source: 100-240V AC,
6. Remove the batteries from theing adaptor as they will become50-60 Hz (Automatic voltage conver-
battery block (h).warm.sion)
� Grip the plug when disconnectingMotor voltage: 2.4 V DC
WARNING:the charging adaptor from a recep-Charging time: 1 hour
Do not attempt to replace the bat-tacle; tugging on the cord may dam-
This product is intended for house-
teries for the purpose of reusingage it.
hold use only.
the shaver. This could result in the� Store the charging adaptor and its
risk of fire or electric shock.cord set in a dry area where it will
be protected from damage.READ ALL INSTRUCTIONS BE-
� The linear motor of the shaver mayFORE USE.
Caution
start operating without the On/Off
� Do not charge the shaver where the
switch on if the shaver is placed
temperature is below 0°C (32°F) or
near a television, stereo, audio-
above 40°C (104°F), where it will
visual equipment or anything that
be exposed to direct sunlight or a
generates strong magnetic field.
heat source, or where there is a lot
Do not place the shaver near these
of moisture.
equipments.
� Use only the included shaver
� The outer foil is very thin. If han-
charging adaptor RE7-01 to charge
dled improperly, it can be easily
the ES8092/ES8094/ES8095
damaged. To avoid personal injury,
shaver.
do not use the shaver if it has a
� The supply cord of the charging
damaged foil or inner blade.
adaptor cannot be replaced; if the
� Wash the shaver in tap water. Do
cord is damaged, the entire charger
not use salt water or boiling water.
should be discarded.
Also, do not use cleaning products
� Dry the shaver completely before
that are designed for toilets, bath-
setting it in the charging adaptor.
rooms or kitchen appliances. Do
� Keep the charging adaptor away
not submerge the shaver for a long
from water and handle it only withFOR YOUR CONVENIENCE, WE HAVE ESTABLISHED A TOLL-FREE
time.
dry hands. Do not use an extension(IN USA ONLY) NATIONAL ACCESSORY PURCHASE HOT LINE AT
� Do not wipe any part of the shaver
cord to connect the charging adap-1-800-338-0552.
with thinner, benzine or alcohol.
tor to an outlet.FOR CANADA, PLEASE CONTACT ONE OF THE SALES BRANCHES
Clean it by using a cloth dampened
MENTIONED ON THE BACK PAGE.with soapy water.
10101111 |
ACEC
