&8".�?´
Easily Check Your Blood Pressure ReadingsRecalling Stored Data
Against the World Health Organization (WHO)
1. Press the Recall button (Fig. 13). The A will appear in the lower part of
Guidelinesthe display, and then the average value of all the stored data will be
displayed (Fig. 14).
Blood Pressure Categories For example, if seven data (measurements) are stored in the memory,
the average value of these seven data will be displayed. If there is no
SYSTOLIC BLOODDIASTOLIC BLOODdata in the memory or if there is only one data in the memory, the A
CATEGORY
PRESSURE (SBP)PRESSURE (DBP)will not be displayed.
2. By pressing the Recall button repeatedly (Fig. 15), you can browse through
Normal< 130< 85
all the stored data sequentially from the newest data to the oldest (Fig. 16).
If no data is in the memory, nothing will be displayed.
Normal High130-13985-89
Note:
Low Hypertensive140-15990-99Press the Recall button lightly and briefly. If the Recall button is pressed
continuously for more than about 2 seconds, all stored data will be deleted.
Moderate Hypertensive160-179100-109
3. Press the Start (On/Off) button to finish.
If the data is recalled while the blood pressure monitor is turned off, the
Severe Hypertensive> 180> 110
monitor will turn off automatically after about 30 seconds.
If your systolic pressure falls in one category but your diastolic pressureFig. 13Fig. 14Fig. 15Fig. 16
in another, your level is classified in the higher of the two categories.
SYS.SYS.SYS.SYS.
mmHmmHmmHmmH
IMPORTANT:
DIA.DIA.DIA.DIA.
WHO does not define a low blood pressure area. For reference, systolicmmHmmHmmHmmH
pressure readings of less than 90 mmH are considered to indicate low
P/min.P/min.P/min.P/min.
blood pressure regardless of the diastolic pressure.
Do not be alarmed by temporarily high or low readings because fluctuationsROn/OffStartROn/OffStartOn/OffROn/OffStart
RStart
in a person?s blood pressure are not uncommon. If possible, measure and
record your blood pressure at the same time every day, and consult your
physician if you have questions or concerns.
If abnormal variations in blood pressure are observed in measurement,
please consult your physician.
Deleting Data
1. Press the Recall button.
2. Press the Recall button again until the recalled data disappears from the
display (about 2 seconds).
ALL data will be deleted. Individual stored data cannot be deleted
independently.
1314 |
ACEC
