Operate the Forward /Reverse lever
.Operationafter the motor rotation is - complete
ly stopped.
Chuck
Note: Grease for bitHammering/drillingswitching
Grease the oval indentatiolen ver
on the bit with the supplied
grease at least once a month.Speed/BlowModeselection
lever
1. There are four modes available with
the combination of Hammering/
drilling switching lever and Speed/
Blow Mode selection lever.
1. To mount the bit Select the suitable mode -for appli
1-1. I nsert a bit into the mounting hocation. le,
and turn it slightly to l-ocate an en
2. Operate the mode change after
gaged position.
the motor rotation is completely
1-2. A t the engaged position, push thset opped.
bit as far as it goes. Make sure that
the bit is fixed by pulling it.Posit ioofnRecommended
Speed/Blow Mode
switching
selection leverapplication
lever
Hard blow hammer-This mode has hard
ing modeblow hammering which
is suitable for concrete
drilling.
Concrete drill
Soft blow hammering This mode is suitable
(Rotation with modefor concrete drilling
hammering)
with smaller diameter
2. To dismount the bitdrill, or for drilling into
2-1. D epress the chuck cover and pull soft base material.
the bit.Small diameter con-
crete drill
High speed drillTihngi sm omdoede is suitable
for metal drilling with
high speed rotation.
Metal drill
Metal hole saw
(Rotation) onSllyow speed drillTihngi sm omdoede is suitable
for wood drill with high
torque.
Foward/Reverselever Wood drill
Variablespeedcontroltrigger
ForwardReverse
To set the center of a hole, pull the trigger
slightly to start the drill rotation slowly.
Be sure to set the switch -in the cen
ter to lock it after use.
- 7 - |
ACEC
