Cable Box Connections
2
f you cable signal uses a cable box or
Cable Signal IN
Idecoder, follow the easy steps below to
from the Cable
complete the connection.Company
Cable Box (w/RF In/Outputs):
This connection will be mono.
21
Connect the Cable CompanyAUDIO INSPDIFIN OUTVIDEO
supplied cable to the signalTOCABLEIRDVD-D OUTR LS-VIDEO
1TV/VCRINAUDIO OUTY Pb Pr
IN(put) plug on the back of theUSBPASSCARDTVOPTICALSPDIF
Cable Box.
Jack Panel Back of Cable Box
Using a separate round coaxial
cable, connect one end to the
2
OUT(put)(TOTV) plug on3
the back of the Cable Box.
Connect the other end of the
round coaxial cable to the 75&75&75&
3
input on the back of the television.
Screw it down finger tight. Round 75&Jack Panel Back of TV
Coaxial Cable
NOTE: If applicable, set the OUTPUT
CHANNEL SWITCH on the back of the
cable box to CH 3 or 4. Tune the TV to
the same channel and change channels
at the cable box. In some cases, the
cable box will automatically tune to
either channel 3 or 4, change channels
until the picture appears.
Helpful Hints
If no Video Signal is present, the TV
will display a OBLUE� screen and shut
itself off in about 5 minutes. If the TV
is tuned to the AV channel and there
is no Video Signal present, the screen
will remain black and the TV will shut
itself off in about 5 minutes. |
ACEC
