Tips for tuning
Changing the pr ogramme numbercheck the picture on all your programmes. The pieces
of a television channelof equipment that are not switched on must be on
stand-by. If any of your programmes have wavy lines
1Press the N and Q buttons together to get the
installation menu on the screen.on the picture when the equipment is switched on,
2Press the menu + button to get the manual storeyou will have to change the output frequency of the
menu on the screen.equipment. Please read the instruction book for the
equipment to find out how to do this. Change the
3Select the channel you want to change byoutput frequency a little at a time (or in 8MHz steps)
pressing the P+, P- or the 0 to 9 buttons.and keep checking all your programmes.
4Press the N and Q buttons together again toWhen there are no wavy lines (or other interference)
make the programme number flash.on any of the pictures, re-tune the programme
5Press P+, P- or the 0 to 9 buttons to enter thenumber that you have chosen for your equipment (see
programme number you want to give to that�Tuning in the programmesO, on pages 2 to 3).
channel. You canOt use 0 because it is reserved forDo the same for each piece of equipment, but after
the scart (AV) channel.youOve finished with each one, leave it switched on
6Press the N and Qbuttons together once morewhile you check the next piece of equipment.
to make �storedO appear. The television has nowContinue until you have all the pieces of equipment
working together without interfering with each other.
stored the television channel on the programmeIf you cannot get rid of the interference, you may
number you have chosen.
7Repeat steps 3 to 6 if you want to change thehave to connect the equipment with a scart cable, (see
programme numbers of other channels.�How to connect scart cablesO on page 8-9).
8Press the menu button twice to get back toChanging channels without leaving
normal viewing. (You can turn off any of thethe installation mode
on-screen displays by pressing the menu buttonAs long as the programme number is not flashing,
several times.)you can change channels while the installation menu
is still on the screen.
Picture interference from other
equipment
If you have used the aerial lead to connect a video
recorder, satellite receiver or other piece of equipment,
switch the equipment on one piece at a time and
Features on the television
Main po werPlease read �Switching the television on and offO on page 2.
switchA
Keep pressing the menu button to display the symbols for the items you canMENU�+
adjust: a (volume), A (brightness), B(contrast), R (sharpness), C (colour)
and C (the timer). If you donOt make any adjustments, the menu display will
automatically disappear after 10 seconds.
When there is no symbol shown on the screen, the - button selects the previous
programme number and the + button selects the next programme number.
Menu adjustmentsVolume is for making the sound louder or quieter. Brightness, contrast,
colour and sharpness are picture adjustments. Your television displays a bar to
show the adjustment. Press + to increase the item you are adjusting, and the bar
will get longer. Press � to reduce the item you are adjusting, and the bar will get
shorter.
4 |
ACEC
