T6460/550/552EZ(EN)_EST.qx3 04.1.28 4:15 PM Page 15
9. Before you call an engineer
If, contrary to expectation, you have any prob-
lems using this TV-Video Combi, it may be
caused by the following reasons.
Your TV-Video Combi does not respond toNo recording possible:
any button being pressed:Y The TV channel you want to record is not
Y There is no power supply: check the powerstored or you selected the wrong programme
supply.number: check TV channels stored.
YParental control is on: switch the parental con-Y A cassette was inserted that does not have
trol off.the security tab (cannot be used to record):
YA programmed recording is currently beingcover the hole with adhesive tape or use a
made: if desired, cancel the programmedcassette with an intact security tab. For more
recording. Please see the section �Problemsinformation, please see the section
and solutions for programmed recordingsO in�Preventing accidental erasingO in chapter
chapter �Programming a recording (TIMER)O.�Manual recordingO.
Y There is a technical problem: disconnect from
the mains power supply for 5 minutes, then[14PV235/ 21PV385]
power-up again.
Resetting devices to default factory settingsNo recording possible:
* Attention: all the information stored (time andY �VPS/PDCO switched on but �VPS/PDC timeO
date, TIMER) will be cleared.wrong: enter �VPS/PDC timeO exactly to the
1. Switch the TV-Video Combi to stand-by.minute. Check your aerial connection.
2. Press and hold REC I and PROG P+ at theSMART Clock does not work:
same time for 2 seconds or more.YYou have stored on programme number �P01O a
Cassette is jammed in the TV-Video Combi:TV channel that does not transmit Teletext.
Store on �P01O a TV channel that transmits
Y DonOt use force. Pull out the mains plug for
the moment. Then, call an engineer.Teletext.
Remote control does not work:YPoor Teletext reception. Store a TV channel on
�P01O with good Teletext reception.
Y Remote control not pointed toward the TV-
Video Combi: point it at the TV-Video Combi.YYou have not activated the SMART Clock func-
Y There is a technical problem: take out the bat-tion. Switch the function �ONO.
teries, wait for 10 seconds and place them
back.
Y Batteries have run out: change the batteries.You can also call the customer service centre
in your country.
No picture when you play a cassette:
Y There is no recording on the cassette:The telephone numbers can be found on page
change the cassette.16 of this operating manual. Have the model
number (MODEL NO.) and the production num-
Poor picture quality when you play a cas-ber (PROD. NO.) of your TV-Video Combi ready.
sette:
YYour TV is not properly adjusted.
Y The cassette is badly worn or of poor quality:
use new cassette.
YTracking is not properly adjusted: turn to sec-
tion �Manual trackingO.
Y Magnetism from nearby appliances and geo-
magnetism might affect the colour of the TV
picture. Move the TV-Video combi away from
such sources. The TV-Video combi will read-
just itself automatically. If you want to initiate
an immediate readjustment, unplug the TV-
Video combi from the mains and plug it in
again approximately 30 minutes later.
EN
15 |
ACEC
