T6450EZ(EN)_UKX.qx3 04.2.12 9:23 PM Page 6
1. Connecting the TV-Video Combi
picture and close the battery compartment.
Important for the United KingdomThe remote control is now ready to use. Its
This apparatus is fitted with a BS1362 5 Amprange is approximately 7 metres.
inside an approved moulded 13 Amp plug.
Connecting the cable
To replace a fuse in this type of plug proceed as
follows:
1.1.Remove fuse cover and fuse.
2.2.Fix new fuse which should be a BS1362 5A,
ASTA or BSI approved type.
3.3.Refit the fuse cover.
If the fitted plug is not suitable for your socket
outlets, it should be cut off and an appropriate
plug fitted in its place. If the mains plug contains1.1.Insert the aerial cable plug into the AERIAL
a fuse, this should have a value of 5A. If a plug
at the back of the TV-Video Combi.
without a fuse is used, the fuse at the distribu-
2.2.Connect the mains cable to the wall socket.
tion board should not be greater than 5A.
3.3.If the little red standby light (STANDBY ) at
The severed plug must be destroyed to avoid a
the front panel of the set is not lit, please
possible shock hazard, or should it be inserted
switch on the set using the main power
into a 13A socket elsewhere.
switch. The power switch is located on the
How to connect a plug:left side panel of the set.
The wires in the mains lead are coloured in4.4.The following screen will appear on the TV.
accordance with the following code:
PLEASE CONNECT AERIAL OR
BLUE- �NEUTRALO (�NO)
CABLE TO THE TVCR
BROWN- �LIVEO (�LO)
4.4.The BLUE wire must be connected to the ter-THEN...
PUSH P+ KEY
minal which is marked with the letter �NO or
coloured BLACK.OR...
FOR PLAY ONLY PUSH PLAY
5.5.The BROWN wire must be connected to the
terminal which is marked with the letter �LO or
coloured RED.You can find more details in chapter �Preparation
6.6.Do not connect either wires to the earth ter-for useO.
minal in the plug which is marked with the let-
Connecting additional devices
ter �EO or by the safety earth symbol or
coloured green or green-and-yellow.You can connect additional devices such as
decoders, satellite receivers, camcorders, etc. to
Before replacing the plug cover, make certain
the EXT1/ AV1 socket.
that the cord grip is clamped over the sheath of
the lead-not simply over the two wires
Preparing the remote control for
operation
The remote control and its batteries are packed
separately in the original TV-Video Combi pack-
aging.You must install the batteries in the
The respective scart socket is usually marked �AVO
remote control before use.
or �TVO on the decoder or satellite receiver.
Selection of the scart socket
Y To select the Scart socket, please enter 0,0,1,
with the keys on the remote control. AV1
1.1.Take the remote control and the enclosedappears on the screen.
Selection of the front A/V sockets
batteries (2 batteries).
Y To select the front A/V sockets, please enter
2.2.Open the remote controlOs battery compartment0,0,2, with the keys on the remote control.
and place the batteries in it as shown in the�AV2O appears on the screen.
EN
4 |
ACEC
