T6310EZ-I(EN).qx3 02.4.10 11:16 AM Page 11
6. Manual recording
General informationLining up recordings (assemble cut)
Use 'Manual Recording' to make a sponta-When you add a further recording to a cassette,
neous recording (for example, a programme cur-which already has a recording on it, a short
rently being shown).blank (flicker) can appear between the old and
the new recording or the picture itself can flicker.
If you want to start and stop a recording manual-
To help reduce these from occurring, proceed as
ly, read the section 'Recording without auto-
follows:
matic switch-off'.
1.1.Find the tape position of the old recording
If you want to start a recording manually but
where you want to insert the new recording.
have it stopped automatically, read the section
'Recording with automatic switch-off'.(e.g.2.2.Look at the last minute of the old recording
not to record to the end of the tape)(playback).
Read the section 'Automatic recording from a3.3.Press STILL22at the tape position where
satellite receiver', if you want a recording to bethe new recording is to go and press
controlled automatically by a satellite receiver.RECORD/OTR I.
4.4.Now start recording as usual by pressing
Recording without automatic
RECORD/OTR Ion the remote control.
switch-offLC
5.5.Stop recording with .
1.1.Insert a cassette.
2.2.Use P+P-or 0..9 to select the pro-Selecting the recording speed (SP
gramme number you want to record, for
or LP)
example, 'P01'.
3.3.To start recording, press RECORD/OTR I.LP allows to double the recording duration on tape
(for example six hours instead of three hours on a
4.4.To stop recording, press LC.
E180 cassette).
1.1.Press MENU.The main menu will appear.
Recording with automatic switch-off2.Select 'RECORD SETUP' with KBLC
2.
(OTR One-Touch-Recording)and confirm with B1 .
1.1.Insert a cassette.SELECT KL CHOOSE B
2.2.Use P+P-or 0..9 to select the pro-
?RECORD SPEED[SP]
gramme number you want to record.
3.3.Press .RECORD/OTR I
4.4.Each time you press RECORD/OTR Iyou will
add 30 minutes to the recording time.
END=EXIT
Preventing accidental erasing of3.3.Select the required recording speed with
B1
cassettes.
4.4.To end, press STATUS/EXIT.
All cassettes (except for rental and pre-recorded
purchased cassettes) have a security tab on the'SP'/'LP'
back of the cassette.'SP': StandardPlay (normal recording speed)
To prevent recordingoffers the usual first-class picture quality.
over important record-'LP': LongPlay (half recording speed, double
ings (erasing), you canrecording time). 6 hours can be recorded on a 3-
remove this security tab.hour cassette (E180) with a somewhat reduced
If you later decide topicture quality.
record on a protected cassette, simply cover the
hole with adhesive tape.
11EN |
ACEC
