T6410EZ(EN).qx3 03.3.22 14:18 Page 4
SpecificationsSupplied accessories
Voltage:220-240V/50HzY Operating instructions
Power consumption (Standbless than 5Wy):Y Remote control and batteries
Rewind time:less than 260 seconds (cassette E-180)
Number of video heads :2
Recording/playback time:3 hours (SP)
(cassette E-180), 6 hours (LP) (cassette E-180)
W eight without packing in kg:11.5
Dimensions in cm (HxWxD):40.0x37.3x38.0
Power consumption :52W
1. Connecting the TV-Video Combi
3.3.If the little red standby light (STANDBY ) at
Preparing the remote control for
the front panel of the set is not lit, please
operationswitch on the set using the main power
switch. The power switch is located on the
The remote control and its batteries are packedleft side panel of the set.
separately in the original TV-Video Combi pack-4.4.Language setting picture will appear on the
aging.You must install the batteries in the
screen.
remote control before use.
W?HLEN KL
?DEUTSCH
ENGLISH
ESPA?OL
FRAN?AIS
ITALIANO
NEDERLANDS
1.1.Take the remote control and the enclosed bat-SVENSKA
FORTSETZEN=MENU
teries (2 batteries).
2.2.Open the remote control's battery compart-
I do not see a Language setting picture
ment and place the batteries in it as shown in* Check the cable connections.
the picture and close the battery compartment.
The remote control is now ready to use.You can find more details in chapter 'Preparation
Its range is approximately 7 metres.for use'.
Connecting additional devices
Connecting the cable
You can connect additional devices such as
decoders, satellite receivers, camcorders, etc. to
the EXT1 socket.
1.1.Insert the aerial cable plug into the AERIAL at
the back of the TV-Video Combi.The respective scart socket is usually marked
'AV'or 'TV'on the decoder or satellite receiver.
2.2.Connect the mains cable to the wall socket.
EN
4 |
ACEC
