T6410EZ(UK).qx3 03.3.22 14:08 Page 15
9. Before you call an engineer
If, contrary to expectation, you have anNo recory prob-ding possible
lems using this TV-Video Combi, it may be*The TV channel you want to record is not
caused one of the following reasons.stored or you have selected the wrong pro-
gramme number: check TV channels stored.
Your TV-Video Combi does not respond to
*A cassette was inserted that does not have the
any button being pressed:
security tab (cannot be used to record): Insert
*There is no power supply: check the power
a cassette with an intact security tab or
supply.change cassette. For more information, please
*Parental control is on:switch the parental con-see the section �Preventing accidental erasingO
trol off.
in chapter �Manual RecordingO.
*There is a technical problem: disconnect from
the mains power supply for 5 minutes, then
[14PV225]
power-up again.
*OPDCO switched on but �PDC timeO wrong: enter
If this doesn't help, you can reset yTV-Video our
�PDC timeO exactly to the minute. Check your
Combi to the default factory settings.
aerial connection.
Resetting devices to default factory settings
Smart Clock does not work
*W arning:All the information stored (TV chan-
*You have stored on programme number �P01O a
nels, time and date, TIMER) will be cleared.
1.Switch the TV-Video Combi to stand-by.TV channel that does not transmit TELETEXT.
Store on �P01O a TV channel that transmits
2.Press and hold REC Iand PROG P+at the
same time for 2 seconds or more.TELETEXT.
*Poor TELETEXT reception. Store a TV channel
A cassette is jammed in the TV-Video Combion �P01O with good TELETEXT reception.
*DonOt use force. Disconnect the set from the*You have not activated the Smart Clock func-
mains and reconnect it again after a fetion.w sec-Switch the function �ONO.
onds.
You can also call the customer service centre
Remote control does not workin your country.The telephone numbers can be
*Remote control is not pointed at the TVfound on the bac-Videok of this instruction manual.
Combi.Have the model number (MODEL NO) and the
*Take out the batteries, wait for 10 seconds andproduction number (PROD.NO.) of yTV- our
place them back in the remote control.Video Combiready.
*Batteries have run out. Change the batteries.
No picture when you play a cassette
*There is no recording on the cassette.
Poor picture quality when you play a cas-
sette
*The cassette is badly worn-out or of poor qual-
ity. Use a new cassette.
*Tracking is not properly adjusted. Turn to sec-
tion �Manual TrackingO.
*Magnetism from nearby appliances and geo-
magnetism might affect the colour of the TV
picture. Move the TV-Video combi away from
such sources. The TV-Video combi will readjust
itself automatically. If you want to initiate an
immediate readjustment, unplug the TV-Video
combi from the mains and plug it in again
approximately 30 minutes later.
EN
15 |
ACEC
