Connect Peripheral Equipment
There is a wide range of video and audio
equipment that can be connected to your TV.
The following connection diagrams show you
how to connect them.
Preparation
Remove the backplate at the back of the TV as
shown on the illustration opposite.
Lay the LCD TV with the screen down on a
table as it will be easier to connect your
peripheral equipment. Please take your
precautions not to damage the screen.
Video recorder
With a eurocableWith an aerial cable only
CABLE
CABLE
............ ...........
...........YY............DC 12VANT INPC INPUTw 1LS-VIDEOVIDEO (MONO) L AUDIO RYY
DC 12V_+ANT INPC INPUTw 1LS-VIDEOx75&YYY YYYVIDEO (MONO) L AUDIO RAV2_+x75&YYY YYYAV2
2
2
1
1
3
VCR
VCR
&Connect the aerial cables 1and 2as
With a eurocable you will obtain a bettershown opposite.
picture quality than with an aerial cable
éSearch for and store the test signal
only.
of the VCR.
&Connect the aerial cables 1,2and theYUnplug the aerial cable 1 from the aerial
eurocable 3 as shown opposite.socket x of your VCR.
YSwitch on your TV and put the VCR on
éPress the Akey on the VCR.
the test signal. (See the handbook for your
The TV will switch to AV1 mode
VCR)
automatically.
YSearch for the test signal of your VCR in
If you want to keep on watching in TV
the same way as you searched for and
mode, press the cursor up/down,+ P - or
stored TV channels. See Manual
press the digit keys.
installation, p. 6
YStore the test signal under a programme
number.
YReplace the aerial cable in the aerial
socket x of your VCR after you have
stored the test signal.
Select the programme number under
which the VCR is stored.
Press the Akey on the VCR.
Connect Peripheral equipment15 |
ACEC
