How to Use the On Screen Display (OSD)
Geometry window
RRototaation, Pincushion, Ttion, Pincushion, Trrapezoid,apezoid,
Balanced Pincushion, PBalanced Pincushion, Pararallelograllelogramam
Follow the steps below to adjust any of the five preset options (ROTATION, PINCUSHION, TRAPEZOID, BALANCED PINCUSHION,
or PARALLELOGRAM).You can make individual adjustments to each of the preset options.Note:use these features only
when the picture is not square.
Press the ON SCREEN
11
DISPLAY button.
2b2bPress the ON
SCREEN DISPLAY
button.Then,
Press "-" or "+"
button to adjust
2a2aPress "-" or "+" buttonuntil the GEOMETRYwindowis
the rotation.
highlighted. Next, press the ON SCREEN DISPLAY button.Then, if
necessary, press "-" or "+" until ROTATION icon is highlighted.
2c2cWhen done,press
the ON SCREEN
To select BALANCED PINCUSHION or
5a5aDISPLAY button to
PARALLELOGRAM, press "-" or "+"
save the change
button until BALANCED PINCUSHION
and return to
5b5bor PARALLELOGRAM icon is
GEOMETRY window.
highlighted. Next, press the ON
SCREEN DISPLAY button.Then
5cfollow steps 4b and 4c to make5c
the appropriate changes.
3a3aTo select
PINCUSHION, press "-
" or "+" button
until PINCUSHION is
4c4cWhen done,press the
highlighted. Next,
ON SCREEN DISPLAY button.
press the ON SCREEN
This will save the
DISPLAY button.
change and return the
screen to GEOMETRY
window.
4a4aTo select3c3cWhen done,3b3b
Press "-" or "+" button (on the
4b4bTRAPEZOID,press the ON
Press "-" or "+" button tolower right-hand corner of the
press "-" orSCREEN DISPLAY
adjust the trapezoid.monitor) to adjust the
"+" buttonbutton.This will
pincushion.
until TRAPEZOIDsave the change
Iconisand return the
highlighted.screen to
Next, press theGEOMETRY
ON SCREENwindow.
Smart HelpDISPLAY button.
To exit GEOMETRY CONTROLS . . .
. . . but continue to another window,press the ONSCREENDISPLAYbutton when OSAVE�is highlighted.Next,press "-" or "+" button until the desired
window � for example � SIZE & POSITION � is highlighted. Now, turn to SIZE & POSITIONOn the next page and follow the instructions, starting with step 2.
. . . completely,press the ONSCREENDISPLAYbutton twice.The On Screen Display disappears.All changes will be saved.
To make changes to one item, follow the steps for that item.Then, follow OTo exit GEOMETRY CONTROLS . . . .�
To return to factory presets, see OTo Reset the OSD� on page 13.
10 |
ACEC
