Connecting peripheral equipment
Rear connection
You can connect any equipment that has a euroconnector socket to your TV set
(video recorder, decoder, etc.).
For further information on connecting a video recorder,refer to its user manual.
Front connections
When the headphones are connected, the sound on the TV set is automatically
muted. Press keys aand to adjust the volume.
Some models have AUDIO / VIDEO connections on the front of the TV set.
There is 1 video input + 1 sound input (mono models) or 2 (L) and (R) sound
inputs for stereo models. For a mono sound camcorder, connect the audio signal to
the AUDIO L input. Use the f-g key to reproduce the sound on the left and right
loudspeakers of the television.
To select the connected equipment
Use the X key on the remote control to select the EXT(1) (rear socket) or
EXT2(front socket:on certain models).
Most equipment (decoder,video recorder) carries out the switching itself.
When a peripheral device provides RGB signals (game,satellite receiver,...),it has priority
over the TV programmes.The peripheral device has to be switched off if you want to watch
the TV channels.If you wish to avoid this inconvenience,configure the peripheral equipment
to provide composite video signals (CVBS PAL/SECAM) instead of RGB signals (refer to the
peripherasl user manual).
Tips
Installation
To avoid any dangerous situations and operating faults, do not place anything on the
TV set and leave a space of at least 5 cm around the appliance.
Impossible to call up the INSTALLATION menu?
The CHILDLOCK function is enabled (refer to page 5).To rapidly unlock all
programmes,call up the CHILDLOCK menu and enter your confidential code.
Set the PROGRAMME item to ALL. Set the LOCK item to YES and then to NO.
All the programmes are now unlocked.
Poor reception or no picture
The proximity of mountains or high buildings may be responsible for ghost pictures,
echoing or shadows. If this is the case, modify the orientation of the outside aerial
and check that the TV channel is tuned in correctly (refer to FINE TUNE page 3).
Does your antenna enable you to receive broadcasts in this frequency range? Have
you chosen the correct system (page 3)?
Are your aerial and euroconnector sockets correctly connected?
If the peripheral equipment connected to the EXT1 is on switch it off.
Standby
To save electricity it is advisable to switch the TV set off using the on/off key on the
front of the set. If the set receives no signal for 15 mins, it automatically switches to
standby mode.
Still no results?
If you have a problem with your TV set, never attempt to repair it yourself: contact
your dealerOs after-sales service.
Recycling directive
Your TV set uses materials which are reusable or which can be recycled.
To minimise the amount of waste in the environment, specialist companies recover
used sets for dismantling and collection of reusable materials (consult your dealer).
8 |
ACEC
