Connections
Depending on the versions, the TV set is equipped with 2 or 3 SCART connectors EXT1, EXT2 and
EXT3 located on the rear.
The EXT1 connector has audio video inputs/outputs and RGB inputs.
The EXT2 connector has audio video inputs/outputs and S-VHS inputs.
The EXT3 connector has audio video inputs.
Video recorderCarry out the connections shown opposite, using the EXT2
connector. Use a good quality SCART connector cable.
If your video recorder does not have a SCART connector,the only possible
CABLE
connection is via the aerial cable.You will therefore need to tune in your
video recorderOs test signal and assign it programme number 0 (refer to
EXT 2
manual installation p.5).To reproduce the video recorder picture,press 0.
Video recorder with Decoder
Connect the decoder to the second SCART connector of the
video recorder.You will then be able to record scrambled
transmissions. See also the SETUP menu (following page).
VCR
Other equipmentSatellite receiver, decoder, DVD, games, etc.
Carry out the connections shown opposite.To optimise
picture quality, connect the equipment which produces the
CABLERGB signals (digital decoder, DVD players, games, etc�) to
EXT1, and the equipment which produces the S-VHS signals
(S-VHS and Hi-8 video recorders) to EXT2, ...). For digital
equipment or a decoder, go to the SETUP menu settings
(see next page).
To select connected equipment
Press n to select EXT1 or EXT2 (or EXT3). Most equipment
(decoder,video recorder) carries out this switching automatically.
Side connections
Make the connections as shown opposite.With the key n,
select FRONT.
For a monophonic device,connect the audio signal to the AUDIO L
*input.Use the e key to reproduce the sound on the left and right
AUDIOspeakers of the TV set.
VIDEO
SYVIDEOHeadphones
The @# keys are used to adjust the volume. Press the
mkey to mute the sound on the TV set (see also sound
settings, page 6).
The headphone impedance must be between 8 and 4000 ohms.
Amplifier
To connect to a Hi-fi equipment, use an audio connection
cable and connect the OL� and OR� outputs of the TV set to
the OAUDIO IN� OL� and OR� input of the Hi-fi equipment.
AUDIO
12 |
ACEC
