Esp Zappa 1333.3 GB only 1/9/06 2:52 PM Page 3
Remote control keys
& Standby1 Sound mode
To set the TV to standby mode. To switch the TV Used to force programmes in Stereo and Nicam
set on again,press b,P @# or 09.Stereoto Monoor,for bilingual programmes,to
é Sleeptimerchoose between Dual I or Dual II.
To select the length of time before the set The Mono indication is red when in forced position.
automatically switches to standby (from 0 to 240 2 Surround Sound
minutes).To activate / deactivate the surround sound effect.In
Ť Select peripherals (p.10)stereo,this gives the impression that the speakers are
Press several times to select the required EXT further apart.For models equipped with Virtual Dolby
connector.Surround*,you can experience Dolby Surround Pro
Ź Teletext keys (p.8) Logic sound effects.
( Dual screen (according to the version)3 Smart picture and sound
To activate/disable the display on 2 screens. The Used to access a series of predefined picture and sound
second screen displays teletext.settings.
§ MenuThe personal position relates to settings selected from the
To call up or exit the menus.menus.
e Cursor / Format4 Teletext call (p.8)
These 4 keys are used to navigate through the 5 Programme selection
menus.(p.9)To access the next or previous TV channel from the
! Volumelist of Favourite Programmes (see p.5).
To adjust the sound level.6 Digit keys
ç MuteDirect access to the programmes.For a 2 digit
To mute or restore the sound.programme,enter the 2nd digit before the dash
0 Screen informationdisappears.
To display / remove the programme number,the 7 Active Control (according to the version)
name (if it exists),the time,the sound mode and Optimizes the quality of the picture according to the
the time remaining on the timer.Hold down for 5 quality of reception.
seconds to permanently display the programme
number on the screen.
Safety Information
Y Plug the TV into a 220V � 240V AC, 50 Hz supply.
Y Disconnect mains plug when :
� the red light below the TV screen is flashing continuously.
� a bright white line is displayed across the screen.
� there is a lightning storm.
� the set is left unattended for a prolonged period of time.
Y Cleaning the TV screen. Never use abrasive cleaning agents. Use a slight damp chamois leather or soft cloth.
Y No naked flame sources, such as lighted candles, should be placed on top of the TV or in the vicinity.
Y Do not place your TV set under direct sunlight or heat.
Y Do not cover or block the TV as it could lead to overheating.
Y Leave at least 5 cm around each side of TV set to allow for proper ventilation.
Y Avoid placing your set (e.g. near the window) where it is likely to be exposed to rain or water.
Y Battery Usage CAUTION � To prevent battery leakage that may result in bodily injury, property damage, or damage
to the unit:
� Install all batteries correctly, with + and � aligned as marked on the unit.
� Do not mix batteries (old and new or carbon and alkaline, etc.).
� Remove batteries when the unit is not used for a long time.
Useful Tips
Y Do not leave your set on standby mode for a prolonged
period of time. Switch off set to allow it to be demagnetised. A demagnetised set supports good picture quality.
Y Do not shift or move the set around when it is switched on. Uneveness in colour in some parts of the screen may
occur.
Y Never attempt to repair a defective TV yourself. Always consult a skilled service personnel.
3 |