4890.1 gb 05 kopie 12-01-2000 11:46 Page 27
Connect Extra loudspeakers / Amplifier
REAR multimedia loudspeakers
You can enjoy Dolby Pro Logic Surround sound by connecting two rear
loudspeakers to be connected or to the connector clips or to the Dolby
Surround output S at the back of your TV.
To the connector clipsorTo the output S
AUDIO
S
RL
REAR
&Connect two Surround Sound rear loudspeakers (min.16 &)&Connect two rear loudspeakers with built in amplifiers (or
to the connector clips at the back of the TV. Always connectan audio amplifier with rear loudspeakers).
both Surround Sound loudspeakers: the left rear loudspeaker
at REAR L; the right rear loudspeaker at REAR R.Connect the audio cables to the rear loudspeakers and to
the Dolby surround output S at the back of your TV as
Push the connector clip down and insert the end of the wire intoshown above.
the opening:the positive wire (the one with the black line) to theThere is only one cinch output for both speakers. Use a
red loudspeaker connection;the negative wire to the blackmono to stereo adaptor.
loudspeaker connection.Do not insert the wires too far.Note:Switch off the TV and the rear loudspeakers before
The Surround Sound loudspeakers should always be locatedconnecting them.
behind or to either side of the listener.If preferred you can alsoéSelect Rear speakers Yesin the Setup menu.See p.7.
hang the loudspeakers on the wall.
See Surround settings, p. 14 for the available Surround
éSelect Rear speakers Yesin the Setup menu.See p.7.modes.
See Surround settings, p. 14 for the available SurroundRear Surround Sound loudspeakers should always be located
modes.behind or to either side of the listener at about 1 m above
Rear Surround Sound loudspeakers should always be locatedthe seated listenerOs head.
behind or to either side of the listener at about 1 m above Adjust the volume of the rear loudspeakers.
the seated listenerOs head.You may make use of the Test tone function in the Surround
Adjust the volume of the rear loudspeakers.settings menu, see p. 13, to have a reference of the loudness
You may make use of the Test tone function in the Surroundof the separate loudspeakers.
settings menu, see p. 13, to have a reference of the loudnessNote:Once you have adjusted the volume of the rear
of the separate loudspeakers.loudspeakers,do not change it while watching TV as the whole
Note:Once you have adjusted the volume of the rear configuration operates with the volume adjustment of your TV.
loudspeakers,do not change it while watching TV as the whole
configuration operates with the volume adjustment of your TV.
Connect Peripheral Equipment27 |
ACEC
