3104 305 4568.1.gb 01-06-1999 09:32 Pagina 30
Headphone
4Insert the plug into the headphone socket nat the front of the TV.
4Press con the remote control to switch off the internal loudspeakers of
n
your TV.
The headphone socket has an impedance of between 8 and 4000 Ohm and
is of the 3.5 mm jack type.
In the SOUND menu select Headphone to adjust the headphone volume and
balance, see p. 17, and to select the audio source for your headphone sound.
Extra loudspeakers
To achieve a better sound effect you can connect 2 or 4 extra loudspeakers,
min. 8 Ohm. See also Spatial and Surround Sound, p. 17.
4Connect the loudspeakers to the connector clips at the back of the TV.
4Push the connector clip down and insert the ends of the wires into the
REAR
openings : the negative wires (usually the darkest ones) to the black connector
mmclips, the positive wires to the red connector clips. On the back of the TV it is8
FRONT
indicated where you connect the FRONT and REAR loudspeakers.
Do not insert the wires too far.
RL
In case of 2 extra loudspeakers :
or
4Connect them to FRONT.................................4Connect them to REAR.
4Connect the front left loudspeaker at4Connect the rear left loudspeaker at
FRONT L, the front right loudspeaker atREAR L, the the rear right loudspeaker at
FRONT R.REAR R.
4Select a low volume and put the5You achieve a surround sound effect.
loudspeaker switch on the back of the TVA loudspeaker kit to achieve Surround
in the c position.Sound, containing two extra boxes only to
5The internal right and left loudspeakers ofbe connected to REAR and 12 m wire can
your TV are now switched off.be purchased from your dealer.
5You achieve a better front sound effect.Do never connect the loudspeakers from
this kit to FRONT.
In case of 4 extra loudspeakers :
4Connect them to REAR and FRONT.
4Press the loudspeaker switch on the back of the TV in the cposition.
5The internal loudspeakers of your TV are now switched off.
If you want to connect more equipment to your TV, consult your dealer.
30 |
ACEC
