With extra loudspeakers connected
Available menu items dependant of the
selected and available Surround modes.
The contents of the Surround settings menu depends on the extra
Surround settings
speakers/amplifiers connected and on the configuration settings selected in
the Setup menu. See Connect Peripheral Equipment, Extra loudspeakers, p. 34
Test startYYYand Install TV Setup, p. 13.
Test stopYYY
If no extra front or rear speakers are connected do not change the predefined
Centre volumeYYYfactory settings of Extra Front and Rear speakers.
BalanceYYYYY
Rear volumeYY
3D effectY
Surround modeYYYYY
HallNote:you can select only those surround modes which can be used with the
Stereobroadcast signal.
Pro Logic
3D surround
Dolby 3 StereoThe graphical representation of the speakers is displayed on screen when
controls are being changed or when in test tone mode.
The drawing on screen is updated according to the chosen setup and the
Surround settings
selected surround mode. Speakers which are active are highlighted.
In 3D surround mode the graphical representation of the rear loudspeakers is
Test start
Test stopreplaced by the symbol ?r.The menu item 3D effect appears and the level
of the 3D effect can be adjusted.
Centre volume
Balance
Rear volume
3D effect
Surround mode
With two extra rear surround loudspeakers connected
The menu item Test which only appears in Dolby 3 Stereo, 3D Surround
mode or Pro Logic, enables you to have a reference of the internal and the
rear loudspeakers loudness.
&Select Dolby 3 Stereo,3D Surround orPro Logic.
éSelect Test startand press the SELECT/OKkey.
A steady noise tone is switched sequentially through each of the available
loudspeakers, for 2 seconds.This gives you a reference of the volume level
from each loudspeaker.
The loudspeakers activated light up in the screen graphic.
Select Centre volume,Balanceor Rear volumeand alter the selected
adjustments.
Select Test stopand press the SELECT/OKkey when you have finished the
adjustments of the speaker levels.
20Use of the menus |
ACEC
