2121.1 gb 13-07-2001 14:21 Pagina 24
To select connected equipment
If the TV is connected to a video recorder with the EasyLink function,in some cases
the TV will be switched on,even when it was in standby.(E.g.playback tape,...)
This is not possible when Child lock On is selected.
Equipment connected with an aerial cable only :
Select the programme number under which you have stored the test signal
with the digit keys.
Equipment connected to a euroconnector or to the front side of
ww
the TV
B
Press the w key repeatedly to select EXT1,EXT2,EXT3 or FRONT,
TVVCRDVDSAT
according to where you connected your equipment at the back or the front
TUNERCDTAPECDRside of your TV.
SQ
MOVIE SPORT CHILD NEWS OTHERRemark :Most equipment (decoder,video recorder,satellite receiver) carries out the
switching itself when they are activated.
ab
If you want to change to TV channels?
Enter the programme number of the TV channel which you want to watch
with the digit keys or press the w key repeatedly to select TV.
Audio and video equipment keys
w
B
TVVCRDVDSATVCR
Most of the audio and video equipment from our range of products can be
TUNERCDTAPECDRoperated with the remote control of your TV.
?
SQ
O?O!A Press the VCR,DVD,SAT,TUNER,CD,TAPE orCDR key according to the
equipment you want to operate with this remote control. See Use of the
!ab
remote control, p. 8.
A
OKMENU
IVideo recorder
Press one of the video recorder keys after you pressed the VCR key:
V?P
?for record,
Ofor rewind,
132
!for stop,
465
Afor play,
798
E
i00 for fast forward,
U
y�ZOOMEfor selecting 1- or 2-digit programme numbers from the video
INSTANT
Ufhrecorder,
?INSTANT
Xq?P
- P +for fast programme selection from the video recorder tuner,
0 to 9 to select a programme number from your video recorder tuner,
Bto switch the video recorder to standby
UVCR timer
These keys function with equipment which use the RC5 signalling standard.
If your video recorder has the EasyLink function,the key INSTANT ? for recording,
under the door of the remote control,can be operated in the TV mode.
If your EasyLink video recorder has the system standby function,press the B key for
3 seconds to switch both TV and the video recorder to standby.
24Connect Peripheral Equipment |
ACEC
