3104 305 4770.5.gb 28-05-1999 11:24 Pagina 9
Surround Sound
To make use of the wireless surround loudspeakers, use the p1 keys to
select the same channel as you selected on the active loudspeaker. (Ex factory,
channel 6 has been selected as default.)
A disturbance free sound reproduction wil be guaranteed under most
circumstances.
To avoid interferences from external RF (wireless) equipment such as a
headphone, RF audio, remote controls for light, ... it may be necessary to shift
to another channel number.
In practice only 3 or 4 channels are available because at least a step of two
channels are necessary to have enough separation.
Always be sure that the active surround speaker and the Surround Sound
setting are switched to the same transmitting channel. Otherwise no sound or
only a distorted sound will be heard on the surround speakers.
PRE-AMP
IN (TV)
When the TV is tuned to a channel in the neighbourhood of 433 Mhz, then the
REARtransmitter is switched off because no RF surround sound is possible. This is
RLnecessary to avoid disturbed picture.
When no RF surround sound is possible or when there is too much
interference, use the wired back up solution. In this case select off in the
Surround Sound menu item.
Connect the supplied cinch cable with the PRE-AMP IN (TV) connector at the
back of the active surround loudspeaker and with the black and red
REAR Ror Lconnector clips at the back of the TV.
FRONT
Installation
Select Installation and press the OK key to return immediately to the
INSTALLATION menu.
To exit from the menu
� Keep the red menu key on the door of the remote control pressed.
9 |
ACEC
