6ENGLISHHD7811, HD7810 Coffee Machine422200197192
4 Clean the coffee outflow unit and the drip tray in hot water, if
necessary with some washing-up liquid, or in the dishwasher (fig. 20).
5Hold the cup tray in your hand while cleaning it with hot water, if
necessary with some dish soap.(fig. 21).
The cup tray can also be cleaned in the dishwasher.
To clean the cup tray, remove it from the machine, as it might prove
sharp when handled incorrectly. Always handle it carefully!
6 Clean the pod holders in hot water, if necessary with some washing-
up liquid, or in the dishwasher (fig. 22).
Check if the hole in the centre of the pod holders is not clogged. If the hole
is clogged, unclog it by holding the pod holder under a running tap. If
necessay, you can use a washing-up brush or a pin to unclog the hole.
7 Clean the water reservoir in hot water, if necessary with some
washing-up liquid (fig. 23).
BThe cover of the water reservoir can be removed to allow thorough cleaning
of the inside.
BIf you are using a washing-up brush, be careful not to damage the valve in
the bottom of the water reservoir.
8 Rinse the parts with fresh water after cleaning and put them back into
the machine.
9 Clean the water distribution plate with a moist cloth (fig. 24).
Be careful when you do this; make sure that the rubber sealing ring does not
get stuck under the edge of the water distribution plate. If it does, the coffee
machine will start leaking!
Descaling.
Regular descaling will prolong the life of the coffee machine and will
guarantee optimal brewing results for a long time. If the machine is used
twice a day on average, it must be descaled once every 3 months.
1 Fill the water reservoir up to the MAX indication with descaler and
water according to the instructions on the package of the descaler.
Then put the water reservoir back into the coffee machine (fig. 2).
Use a descaler based on citric acid.
2 Press on/off button I (fig. 10).
The machine is ready for use when the pilot light burns continuously.
3 Place the 1-cup pod holder in the coffee machine, preferably with a
used coffee pod in it. Close the lid and make sure it is properly
locked.
We advise you to put a used coffee pod in the pod holder when you
descale the machine. This pod will serve as a 'filter' to prevent the hole in
the pod holder from getting clogged with scale residues.
4 Put a bowl with a capacity of at least 1500 ml under the coffee
outflow openings to collect the mixture of descaler and water (fig. 8).
5 Press the °° button for 2 cups and let the appliance operate.
Repeat this until the water reservoir is empty (fig. 25). |
ACEC
