Active Control
The TV continuously measures and corrects all§Press the cursor right to select Active
incoming signals in order to provide the bestDisplay.
picture possible.
ePress the cursor up/down to select Show bars,
one of the Dual screen demos or Off.When
&Press the hkey on the remote control.
you select Dynamic contrast, Pixel Plus, Digital
Note:Switch off all menus on screen.
Noise Reduction or Digital Natural Motion, the
éThe Active Control menu appears.TV screen is divided into two parts: in the left
part the selected picture quality setting is
Press the cursor up/down to select the Active
switched off; in the right part it is switched on.
Control values Off,Minimum,Medium or
Note:Dependent on the input signal,one or more
Maximum.
The picture settings are being optimisedDual screen demos may not be selectable.
continuously and automatically which is!Press the hkey again to switch off the Active
displayed by bars.Those menu items can not beControl menu.
selected.
Press the cursor right to select Smart
Picture.
(Press the cursor up/down to select one of the
predefined picture settings.
Sound&Press the cursor right to select Sound.
éSelect the menu items in the Sound menu with the cursor
Sound
up/down and adjust the settings with the cursor
TV
left/right.Remember, control settings are at normal mid-range
Smart sound
levels when the bar scale is centred.
Equalizer
VolumeSmart sound
Balance
Select Smart sound to display a list of predefined sound settings,
Loudness
each corresponding with specific factory settings of Treble and
Headphone volume
Bass.Personal refers to the personal preference settings of
Surround mode
sound in the sound menu.
(Dual I-II)
(Mono/Stereo)
Notes:
(Nicam/Analogue)
- Some menu items are only available in case of a Cinema Link
(3D effect)
configuration and when the Cinema Link is activated.Others are
AVL
steered by the audio receiver instead of by the TV.See the separate
Delta volume
Cinema Link booklet supplied,p.26.
- Dual X is only available with dual sound transmission.
- Mono/Stereo is only selectable in case of analogue stereo
transmission.
- Nicam/Analogue is only selectable in case of Nicam transmission.
12 |
ACEC
