USINGTHE MENUS :PICTURE
Using Manual Converge : Multipoint Red/Blue
PICTURE
MANUAL CONVERGE
The Multipoint Red/Blue convergence controls allow you to adjust
YCONVERGE RED
picture convergence at specific points on the TV screen.YCONVERGE BLUE
GMULTIPOINT REDY 0
Note: Allow the TV to warm up for 20 minutes before adjustingYMULTIPOINT BLUE
YSAVE MULTIPOINT
convergence. Adjust Converge Red or Converge Blue before usingYYto Navigate EXIT to Adjust
the Multipoint Red/Blue controls. See the previous page.
Select MULTIPOINT RED or MULTIPOINT BLUE in
1the MANUAL CONVERGEmenu.
Press the cursor right to enter navigate mode.
to Navigate EXIT to Adjustto Adjust EXIT to Navigate
2
Use the cursor left, right, up, or down to move to a cross
hair that has a color outline.
3
Press the m (Status/Exit) key to enter adjust mode.
4
Use the cursor left, right, up, or down to adjust the crossto Navigate EXIT to Adjustto Adjust EXIT to Navigate
hair until the color outline is gone.
5
PICTURE
MANUAL CONVERGE
Press the m key to return to navigate mode.
YCONVERGE RED
6YCONVERGE BLUEG0
MULTIPOINT REDY
YMULTIPOINT BLUE
Repeat steps 3�6 until all misaligned cross hairs have been
YSAVE MULTIPOINT
adjusted. Then press the MENU key.YY
7to Adjust EXIT to Navigate
For your multipoint adjustments to be stored in the TVOsSAVE MULTIPOINT
memory, you must activate SAVE MULTIPOINT .
8PICTUREPICTURE
MANUAL CONVERGEMANUAL CONVERGE
YCONVERGE REDYCONVERGE RED
Note : If you are not satisfied with the adjustments you justYCONVERGE BLUEYCONVERGE BLUE
made and want to start over, you can use the UNDOYMULTIPOINT REDYMULTIPOINT RED
YMULTIPOINT BLUEYMULTIPOINT BLUE
MULTIPOINT control. This control allows you to undoGSAVE MULTIPOINTY 0GSAVE MULTIPOINTY 0STORED
YYYY
the adjustments, but only if you use it before saving.
To save your multipoint adjustments : Select SAVEOR
MULTIPOINT and press the cursor left or right.
UNDO MULTIPOINT
PICTUREPICTURE
To undo your multipoint adjustments : Select UNDO
MANUAL CONVERGEMANUAL CONVERGE
MULTIPOINT and press the cursor left or right.YYCONVERGE BLUEYYCONVERGE BLUE
YMULTIPOINT REDYMULTIPOINT RED
YMULTIPOINT BLUEYMULTIPOINT BLUE
YSAVE MULTIPOINTYSAVE MULTIPOINT
To restore the TVOs picture convergence to factory settings,GUNDO MULTIPOINTY 0GUNDO MULTIPOINTY 0RESTORED
select RESTORE FACTORY and press the cursor left orYY
right.
OR
Press the MENU key to return or the m key to switch theRESTORE FACTORY
menu off.
9
PICTUREPICTURE
MANUAL CONVERGEMANUAL CONVERGE
YYYMULTIPOINT REDYYYMULTIPOINT RED
YMULTIPOINT BLUEYMULTIPOINT BLUE
YSAVE MULTIPOINTYSAVE MULTIPOINT
YUNDO MULTIPOINTYUNDO MULTIPOINT
GRESTORE FACTORYY 0GRESTORE FACTORYY 0RESTORED
17 |
ACEC
