Picture-in-Picture (PIP) Y Basic Connections
USING PIP (BASIC CONNECTIONS )
icture-In-Picture (PIP) is thePIPWindow2
Back of TV
Pshowing of two pictures on the TVANTENNA IN 751MONITOR OUTAV1 INAV2 IN
Y
screen at the same timeNone mainVIDEO
screen picture and one small picture,PbS-VIDEO
MONO/L
Main Screen
or PIP.AUDIOPr
R
NOTE:The PIPpicture must be sup-
plied by a VCR (or other accessory
device equipped with a VIDEO
OUT[PUT] jack). The following con-
Back of VCR
nection example uses the AV1OUTOUT
ANTENNA
IN(puts), but you may use AV2OUT
VIDEOL AUDIOR
Outdoor or
instead, if you would like. IndoorANTENNAIN
AntennaININ
BEGIN
OR
Connect an antenna or cable TV1
Cable TV Signal
signalto the ANTENNA IN(put) on
the back of the VCR.
Connect the VIDEO OUT jack
on the VCR to the AV1 IN(put) forVCR in
TV Mode
VIDEO on the back of the TV. 3
Also connect the AUDIO OUT(puts)
AVi+SAP
(R and L) jacks from the VCR to theTV
VCR123
12:00VCRACC
AV1 IN(puts) (R and L) for AUDIO0646
12:005
on the back of the TV.06789
SMARTSMART
0
Turn the VCR and TV on.Channel SelectionMENUSURF
6Through VCR
Place the VCR in TV modeNUse
the VCR/TV button on the VCR.
CH
4
Press the PIP on/off buttonon
12:00NOTE: When selecting
19INCR. SURR.PIPA/CH
the TV remote.5channels on the VCR
for the PIP window, use
The PIP window should show in oneUP PIP CH DNthe CH(annel) Scan
(+, �) buttons rather
of the corners of the TV screen.
than the PIP CH(annel)
UP/DN buttons.
Press the PIP SOURCE buttonSMART HELP
on your TV remote until the input
Remember, be sure the TV
source to which you connected your
remote is in the correct mode
VCR (in this example, AV 1) appears
when you switch back and forth
in the PIP window.
between the VCR and the TV.
Select the channel on the VCR to
If you see the same picture on the
view in the PIP window. You can domain screen and in the PIP window,
this with your TV remote (in VCR
you need to be sure you have select-
mode) if you have set it to work withed the source to which you connected
your VCR (see page 42).the VCR.
Put the TV/VCR/ACC switch on theFor other possible PIP connections see
remote in TV mode and select thethe OMore PIP Connections� section.
channel on the TV to view on the
If you have a single (monaural) audio
main screen.
output VCR, OY� connectors are
available to complete your connec-
tion. Contact your dealer, or our Parts
Information Center at
1-800-851-8885 for details.
47 |
ACEC
