Remote Control Y Working Accessory Devices
SETTINGTHE TV REMOTETO WORK ACCESSORY DEVICES
SEARCH METHOD
Satellite Receiver
our TVremote can be set to work
06
Yvarious accessory devices (VCRs,
07
Cable TV Converter
cable converters, and satellite08
06
receivers, for example) by what isVCR0709
1
called the Search Method.08
NOTE: The Search Method works0609
only with devices equipped with07
08
Channel Display Indicators or that
093
capability. If the Direct Access code
number method (shown in the previ-
ous section) did not enable your TV
remote to work your accessory device,
then follow the easy steps listed below.
Please read the steps once before per-POWER
forming them.
BEGIN
TVVCRACC
Turn on the desired device. PressSWAPPIP CHSOURCE FREEZE
DNUP
and hold down the VCR or ACC
SOUNDPICTURE
(for an accessory device other than
2
a VCR) mode button on the TVSTATUS/SELECTMENU/4
EXIT
remote. Then press and hold down the
NOTE: The remoteOs
SURF button as you hold down the
back light will blinkMUTE
desired mode (VCR or ACC) button.VOLCH
as the remote moves
through its product
NOTE: You must press and hold
132
code list. After thedown the desired mode (VCR or
465
remote identifies the
ACC) button first and then press and
product code for your798
hold down the SURF button second.TV/VCR
accessory device andA/CH0SURF
While holding down the SURF you release the remote
POSITIONPIP
and the desired mode (VCR orbuttons, the back light
2
ACC) buttons at the same time, will blink twice.
4
point the remotetoward the accesso-
ry device and continue holding the
buttons down.
Watch the Channel IndicatoronSMART HELP
your accessory device. Channel num-
Y Your TV remote may
bers will scan up when the TV remote
locate the accessory deviceOs
has identified the correct code for
code quickly or require several
your accessory device. This may take
minutes to do so.
several minutes.
Y DonOt let the accessory device scan
Release the mode (VCR or ACC)up more than five channels when
and SURF buttonsas soon as chan-the correct code is foundNthe
nel numbers start to scan up. Theremote may pass up the right code
scanning means that your TV remoteand have to repeat the search
has found the code for your accessorycycle.
device. Y If no channel change happens after
several minutes, repeat steps 1�4.
Then if a channel change still does
not occur, the remote will not
work the desired accessory device.
46 |
ACEC
