Cleaning or Replacing the Filters
The Cineos TV has two filters that cover air
inlets on the bottom of the set. Maintaining a
free flow of air through the inlets is very impor-
tant. If the air filters become dirty, clogged, or
blocked, the temperature in the set will rise.
Should the heat level become too high due to
blockage, a sensor detects this, and a warning
message appears on screen alerting you to
check the air inlets for blockage. The message
2C
SERVICE 1G S-VIDEODVI
will be displayed for 6 seconds. It reappearsAV1RLV
MONOUTRLPrPbVYRL
every 15 minutes as long as the temperatureRLG S-VIDEOVRL
AV5AV6RGB+HV
SUB OUTAV2RLSTANDARD/PrPbY
remains too high.AV3AV4STHD INPUTSRLANDARD/HD INPUTSPrPbYTUNER
If the internal temperature of the TV rises to
high, a warning message alerts you that the TV
is shutting down. If the temperature remains at
this high level for 1 minute, the TV will enterLocations of Air Filters
Standby mode. In Standby mode, the TV is off.
Be sure the TV is not placed on a surface (such
as a shag carpet) that will prevent the free flow
of air through the inlets, and periodically clean
or replace the filters as detailed in the following1
instructions.
W ARNING: Do not tip the TV when remov-
ing or installing the filters. This may result in
instability of the TV.
Place your fingers under one of the fil-
ter slots located at either bottom left or
1
right in back of the TV cabinet.
2
Grasp the filter and gently pull it
straight out.
2
Examine the filter for dust or otherR TE NECCENTER
contamination. If it is dirty, clean it
3
with a vacuum cleaner. DO NOT
W ASH it. Replace the filter if vacuum-
ing does not sufficiently clean it.
To order replacement filters, call the3
Philips Customer Care Center at TECREN
CENTER
1-800-531-0039. The part number for
the Philips TV inlet filter assembly is
3135 037 51810.
W ARNING:
DO NOT operate the TV without fil-
ters. This will cause serious damage to
the TV.
4
Turn the filter so that the arrow is
pointing toward the center of the TV.
4
Align the edges of the filter with the
R TE NECCENTER
slot track, then gently slide it all the
way back into the slot. A click sound
can be heard as the filter reaches the
correct position.
70 |