14ENGLISHENGLISH15
C3Brush out hairs from the inside of RazorC7Remove and clean one cutter and comb at
Head Assembly and hair chamber.a time.
Do not clean more than one cutter and comb at
time, since they are all matching sets. If you
accidentally interchange the cutters and combs, it
C4Replace the Razor Head Assembly back oncould take several weeks before optimal shaving
razor.performance is restored.
8 Separate the cutter from the comb.
Every Two Months: Razor HeadsC9Only brush the cutter in an upward
motion. Use the short bristled side of the
Do not mix up the cutters and combs as the brush.
shaving performance may be adversely affected
for several weeks before optimal shaving C10Brush the slots of the comb.
performance is restored.For optimum performance, razor cutters and
combs should be cleaned in a degreasing liquid
1 Turn razor to OFF (O) position and(e.g. Norelco Razor Head Cleaner, model RC1776
disconnect from outlet.or alcohol) and lubricated with Norelco Razor
Lubricant, model AL80, or one drop of mineral oil
C2Press the Razor Head Release Button and(in the center of the head).This helps prevent
remove Razor Head Assembly from thewear of the shaving heads.
razor unit.
C11Replace the cutter and comb into the
C3Brush the inside of the razor housing.Razor Head Assembly.
4 Turn Razor Head Assembly over so that12 Repeat the process for the other two sets
underside is exposed.of cutters and combs.
C5Turn wheel of frame counterclockwise.13 Replace the frame.
6 Remove the frame and brush clean.C14Turn the wheel clockwise until it locks into
place. |
ACEC
