7735X DFU 12_12_03 12/12/03 3:45 PM Page 22 (Black plate)
22ENGLISH
C3Remove the Razor Head Assembly and
clean the razor heads and hair chamber by
running under hot water. Be sure water is
not too hot so as to cause burns or
scalding.
2C4While holding Razor Head Assembly in
one hand, turn center wheel
1counterclockwise to release and remove
frame. Set frame aside.
C5Remove and clean one cutter and comb,at
a time.
Do not clean more than one cutter and comb at
a time since they are all matching sets. If you
accidentally interchange the cutters and combs, it
could take several weeks before optimal shaving
performance is restored.
C6Cutter should be held with cutters facing
up and brushed in an upward motion.
Clean razor comb with long bristles of
brush in a circular motion.
For optimum performance, razor cutters and
combs should be cleaned in a degreasing liquid
(e.g., Norelco Razor Cleaner, model RC1776, or
alcohol) and lubricated with Norelco Razor
Lubricant, model AL80, or one drop of mineral oil
(in the center of the head).This helps prevent
wear of shaving heads.
C7While holding Razor Head Assembly in
one hand, replace cutter and comb back |
ACEC
